Uline H-7238 Guia De Inicio Rapido página 4

PAGE 4 OF 12
ASSEMBLY CONTINUED
14. Carefully lay the attached receptacles on their side
Figure 10
15. With the receptacles on their side, place three of the
Figure 11
16. Attach the slats to the connector using the 2" lag
17. Carefully flip the receptacles and lay them on the
Figure 12
18. Place the rigid liners inside the cans and place the
Figure 13
1-800-295-5510
uline.com
and attach the connector to the second receptacle
at the bottom ring using the 3½" lag screws and flat
washers. (See Figure 10)
remaining slats on the connector in the designated
slots. You can use a long level or similar flat piece to
properly align the tops of the slats. (See Figure 11)
screws and flat washers. (See Figure 12)
opposite side. Attach the slats to the connector using
the 2" lag screws and flat washers. (See Figure 12)
plastic reclycling and trash lids on top.
(See Figure 13)
0621 IH-7238