Descargar Imprimir esta página

Enerpac TSP Pro Serie Hoja De Instrucciones página 2

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 9
40 to 68°F [5 to 20°C] before pressurizing the wrench.
WARnInG: The pivoting portion of the TSP swivel is
comprised of two swivel arms, fastened together with a
bolt. Never operate wrench with the bolt loosened or
missing. Serious personal injury and damage to wrench
components may result.
4.0 RePLAcInG An exISTInG MAnIfoLd PoST And
SWIveL WITh The TSP100MK oR TSP200MK:
1.
Remove the retainer ring from the top of the manifold post.
Carefully slide the existing swivel off of the manifold post.
2.
Remove the four retaining bolts securing the manifold post.
Gently pry the manifold post from the cylinder body.
3.
Install two new O-Rings into the base of the new manifold
post.
4.
Wipe the cylinder body surface clean. Then, apply a small
amount of Loctite 243 thread sealant to the threads inside
the cylinder body.
5.
Align bolt holes and place the new manifold post on the
cylinder body. Be sure that the O-rings installed during step
3 remain in place.
Important: In the following step, DO NOT coat the bolt threads
with oil or grease.
6.
Install the four retaining bolts provided with the new manifold
post. Tighten them to the torque applicable to your wrench
model:
a. S1500, S3000, W2000 and W4000: 3.7 ft-lbs [5.1 Nm].
b. S6000, S11000, S25000, W8000 and W15000: 7.5 ft-lbs
[10.2 Nm].
7.
Install the provided O-Rings on the manifold post and in the
manifold block.
8.
Reinstall the coupling, nipple and adaptor from the existing
swivel and install them onto the TSP swivel. Refer to Section
3.0.
9.
Install the TSP swivel onto the manifold post. Refer to steps
5 through 7 of Section 2.0.
9
10
21
17
18
20
7
14
Mounting Arrangement - TSP Pro Series Swivel
2
11
1.
Cylinder Body
7.
Manifold Post
9.
Nipple
10. Adapter
11. Coupling
14. O-Rings, Manifold Post (2)
17. O-Ring, Manifold Block
18. O-Rings, Manifold Post Base (2)
20. Retaining Bolts (4)
21. Retainer Ring, Circlip
noTeS
• TSP swivel assembly includes
manifold block and swivel arms
(pre-assembled)
• Replace O-Rings (items 17 and 18)
before installing TSP swivel
• Replace O-Rings (items 14) before
installing new manifold post
• Apply Loctite 577 to threads of
items 10 and 11 before assembly
Refer to Section 3 for torque
specifications and important
assembly instructions.
• Apply Loctite 243 to threaded
holes of body (item 1)
• Refer to Ssection 4.0 for retaining
1
bolt (item 20) torque specifications

Publicidad

loading

Este manual también es adecuado para:

Tsp100Tsp100mkTsp200Tsp200mk