Installing The Hob; Selecting The Installation Location - Dometic CC09 Instrucciones De Uso

Installing the hob

Control elements
No. in fig. 1,
Description
page 2
1 Cooking zone
2 Simmer cooking zone
3 Warning LED "Hot surface"
This LED lights up when the cooking zone is switched on.
It stays lit until the surface has cooled down and can be safely
touched again (this takes about 12 minutes once the cooking
zone has been switched off).
4 Control LED
This LED lights up green when the cooking zone is switched
on.
5 Control knob with three settings (neutral position, large flame
and small flame)
Press and turn clockwise or anti-clockwise to set the required
temperature.
Turn the knob anti-clockwise to open the gas cock.
Turn the knob clockwise up to the stop to close the gas cock.
Only CC09, CC11: The front control knob corresponds to the cooking zone
on the right and the rear control knob to the cooking zone on the left.
6 Installing the hob
The hob can be installed in your kitchen worktop.
6.1

Selecting the installation location

When selecting the installation location, observe the following instructions:
 Select a well-ventilated location for the device.
 Select a covered place to prevent water or any other liquids splashing di-
rectly onto the hob.
 Observe the minimum distance according to fig. 2, page 2.
 Underneath the hob, air vents must have a cross-section of at least
50 cm² for the combustion air supply and heat discharge.
Die Lüftungsöffnungen müssen mindestens 5 mm breit sein.
10
All manuals and user guides at all-guides.com
CC09, CCK09, CC11
EN