Automated Learning Process/Activating Code - Harbor Breeze E-LUK52HBB5LEDR Manual De Instrucciones

AUTOMATED LEARNING PROCESS/ACTIVATING CODE

CAUTION: The remote control transmitter (O)
can be programmed to multiple receivers or fans. If
this is not desired, turn wall switch off to any other
programmable receiver or fan.
Remove battery cover from back side of remote
1.
control transmitter (O).
Locate dimmer switch located
switches--dimmer switch is labeled with a "D" and an
"X". Dimmer switch is pre-set to the "OFF" [X]
position. Most LED bulbs, including the LED bulbs
provided with this fan, are not compatible for use
with dimmer controls; therefore, the dimmer switch
must remain in the
Install the 12-volt battery (P) and then replace
battery cover on remote control transmitter (O).
2. Restore electrical power. Within 30 seconds of
restoring electrical power, press the "
the front of the remote control transmitter (O) for 5
seconds or until light on the fan blinks twice.Use the
remote control to test the light and fan functions (see
operating instructions on pages 15 and 16) to
confirm the learning process is complete.
IMPORTANT: To prevent damage to remote control
transmitter (O), remove the battery (P) if not used for
long periods. Store the remote control transmitter
(O) away from excess heat or humidity.
to the right of the code
"OFF" [X] position.
1
(back side)
2
" button on
14
Code Switches
Dimmer
Switch
O
Lowes.com/harborbreeze
Battery
Cover
P
O
(front)