System Connection - Campbell Hausfeld STANDART DUTY PW1676 Guia De Inicio Rapido

Assembly Instructions and Parts List
Garden Hose and System Connection
GARDEN HOSE CONNECTION
INSTRUCTIONS
1. Attach nipple adapter to inlet fit-
ting on the unit (this may already
be attached to the pump).
2. Attach quick connect fitting to gar-
den hose.
Quick Connect Fitting
"A"
Nipple
Adapter
Figure 10 - Garden Hose Connection
3. Pull side "A" of quick connect
fitting toward garden hose and
push onto nipple adapter.
4. Push side "A" of quick connect
fitting towards nipple adapter and
release.
Garden
Hose
Figure 13 - Connection Call-Outs
www.campbellhausfeld.com

SYSTEM CONNECTION

1. Insert lance into the gun and turn
clockwise to positive stop as shown
in Figure 11.
Figure 11 - Gun/Lance Connection
Garden
Hose
2. Ensure that the power switch is in
the "OFF" position.
3. Attach the high pressure hose and
gun assembly to the unit.
4. Connect garden hose as explained
under Garden Hose Connection
Instructions.
5. Plug the power cord into a ground-
ed 120V outlet and press the reset
button as shown in Figure 12. THIS
MUST BE DONE EACH TIME THE
UNIT IS PLUGGED INTO AN OUTLET.
Electrical Cord
with GFCI
13 mm
Figure 12 - Grounded plug/reset button
6. Turn water on.
7. Depress and hold the trigger on the
8. Turn the "ON/OFF" switch to the
NOTE: REFER TO PRODUCT MANUAL
FOR OPERATING INSTRUCTIONS
Handle/Detergent
Tank
Outlet
2
PW1676
Reset
gun for one minute to release pres-
sure and remove any air trapped in
the system.
"ON" position.
Gun
High
Pressure
Hose