REVAMP Professional CL-2500 Manual Del Usuario página 4

CREATING PERFECT HOLLYWOOD CURLS
A
• Separate each layer of hair into sections of 3 cm wide. Smooth each section of hair by
brushing or combing through the section (from scalp to hair ends) prior to curling.
• VERY IMPORTANT - When curling your own hair, be sure to hold the device with the
buttons facing towards you, see (A). If curling a friend's hair for them, have the buttons
facing towards their face. Always make sure that the control buttons with the REVAMP
logo located on the front of the product are facing you or your friend's face.
• Thread the top of the hair through the small recess at the front of the product, then
down through the deeper aperture at the back of the product as shown in (C). Hold the
appliance around 50-75mm away from your head. (A)
C
• Choose the direction of the curl by pressing the right or left curling button (feature
2) as shown in diagram D. Work on one side of the head at a time. When you move on
to the other side, press the opposite direction curling button so that your curls are
symmetrical (D).
• VERY IMPORTANT - Please do not put your fingers in the deeper aperture at the back of
the product or try to touch the hot barrel.
• Thread the top of the hair through the small recess at the front of the product and
down through the deep aperture at the back, then press and hold the curling button.
The hair will be automatically wrapped around the heated barrel.
• Keep holding the button while the hair is wrapped around the barrel and until you hear
the beep.
• The curling system stops and a beep is heard after 15 seconds which is sufficient time
to curl normal hair.
• After hearing the beep, release the curl button. The rotating clip will have stopped and
you can lower the appliance from the hair to release your curl.
• Caution! When the curling mechanism has stopped, always
A pull the product downwards to release the curl.
• Repeat for each hair section, allowing each curl time to
cool in between.
• After use, switch off the appliance, unplug and allow to cool
before storing away.
• THE PRODUCT MAY JAM IF TOO MUCH HAIR IS FED AROUND
THE BARREL. In this case, the product will automatically
shut off. Simply pull product down to release the hair and
turn back on again to continue using.
Follow us on www.revamphair.com for the latest hair tips and advice.
B
B
D E