Overview; Unpacking Inspection; Safety Information; Rules For Safe Operation - ADInstruments AD233 Manual De Usuario

página de 33

/ 33
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

Modelo AD233: MANUAL DE USUARIO

Overview

This Operating Manual covers information on safety and cautions. Please read the relevant information carefully and observe all the Warnings and Notes strictly.

Warning

To avoid electric shock or personal injury, read the "Safety Information" and "Rules for Safe Operation" carefully before using the Meter.

Model UT233 is a digital power clamp meter (hereafter referred to as "the Meter") is a handheld intelligent power meter which has both the features of digital current meter and

also power measurement meter.

The Meter can measure Voltage, Current, Active Power, Apparent Power, Reactive Power, Power Factor, Phase Angle, Frequency, Active Energy and Phase Rotation Test

Unpacking Inspection

Open the package case and take out the Meter. Check the following items carefully to see any missing or damaged part:

In the event you find any missing or damage, please contact Abacanto Digital, S.A.

Safety Information

This Meter complies with the standards IEC61010: in pollution degree 2, overvoltage category (CAT. III 600V, CAT IV 300V) and double insulation.

CAT. III: Distribution level, fixed installation, with smaller transient overvoltages than CAT. IV.

CAT IV: Primary supply level, overhead lines, cable systems.

Use the Meter only as specified in this operating manual, otherwise the protection provided by the Meter may be impaired.

In this manual, a Warning identifies conditions and actions that pose hazards to the user, or may damage the Meter or the equipment under test.

A Note identifies the information that user should pay attention to.

International electrical symbols used on the Meter and in this Operating Manual are explained on page XX.

Rules For Safe Operation

Warning

To avoid possible electric shock or personal injury, and to avoid possible damage to the Meter or to the equipment under test, adhere to the following rules:

z Before using the Meter inspect the case. Do not use the Meter if it is damaged or the case (or part of the case) is removed. Look for cracks or missing plastic.

Pay attention to the insulation around the connectors.

z Inspect the test leads for damaged insulation or exposed metal. Replace damaged test leads with identical model number or electrical specifications before

using the Meter.

z Do not apply more that the rated voltage, as marked on the Meter.

z When measurement has been completed, disconnect the connection between the test leads and the circuit under test, remove the testing leads away from the

input terminals of the Meter and turn the Meter power off.

z Do not carry out the measurement when the Meter's back case and / or battery door is opened to avoid electric shock.

z When the Meter working at an effective voltage over 30V in AC, special care should be taken.

z Use the proper terminals and function for your measurements.

z Do not use or store the Meter in an environment of high temperature, humidity, explosive, inflammable and strong magnetic field. The performance of the Meter

may deteriorate after dampened.

z Do not use the Meter if the surface of it is wet or the user's hands are wet.

z When using the test leads, keep your fingers behind the finger guards.

z Replace the battery as soon as the battery indicator

personal injury.

z When opening the battery door, must make sure the Meter is power off.

z When servicing the Meter, use only the same model number or identical electrical specifications replacement parts.

z The internal circuit of the Meter shall not be altered at will to avoid damage of the Meter and any accident.

z Soft cloth and mild detergent should be used to clean the surface of the Meter when servicing. No abrasive and solvent should be used to prevent the surface of

the Meter from corrosion, damage and accident.

z Turn the Meter off when it is not in use and take out the battery when not using for a long time.

z Constantly check the battery as it may leak when it has been using for some time, replace the battery as soon as leaking appears. A leaking battery will damage

the Meter.