Tabla de contenido
Publicidad
Operation
Symptom
No function except for cassette ejection
works.
The date or time indicator displays bars
(--:--:--).
The End Search function does not
activate.
The tape does not move when a tape
transport button is pressed.
No sound or only a low sound is heard
when playing back a tape.
Excessive high-piched sound is heard.
Recording stops in a few seconds.
The autofocus function does not activate.
The fader function does not work.
Picture
Symptom
The image on the viewfinder screen is not
clear.
A vertical band appears when a subject
such as lights or a candle flame is shot
against a dark background.
The menu is not displayed on the TV.
The playback picture is not clear.
The picture is "noisy".
The picture is too bright or too dark.
A vertical band appears when shooting a
very bright subject.
Cause and/or corrective actions
• Moisture condensation has occurred.
m Remove the cassette and leave the camcorder for at
least 1 hour. (p. 75)
• Reset the date and time. (p. 67)
• The cassette was ejected after you recorded on it.
m The End Search function will not activate until you
make a new recording after reinserting the cassette.
• The POWER switch is set to CAMERA or OFF.
m Set it to PLAYER. (p. 23)
• The tape has run out.
m Rewind the tape or use a new one. (p. 23)
• The stereo tape is played back with HiFi SOUND set to 1
or 2 in the menu system.
m Set it to STEREO. (p. 32)
• The picture has been recorded with WIND set to ON in
the menu system.
m When there is no wind, set it to OFF. (p. 32)
• The START/STOP MODE switch is set to 5SEC or
m Set it to
. (p. 15)
• Focus is set to the manual mode.
m Set it to autofocus. (p. 45)
• Shooting conditions are not suitable for autofocus.
m Set focus to manual mode to focus manually. (p. 45)
• The START/STOP MODE switch is set to 5SEC or
m Set it to
. (p. 15)
Cause and/or corrective actions
• The viewfinder lens is not adjusted.
m Adjust the viewfinder lens. (p. 13)
• The contrast between the subject and background is too
high. The camcorder is not malfunctioning.
m Change locations.
• DISPLAY on the Remote Commander has not been
pressed.
m Press DISPLAY on the Remote Commander. (p. 23)
• EDIT is set to ON in the menu system.
m Set it to OFF. (p. 32)
• The video heads may be dirty.
m Clean the heads using the Sony V8-25CLH cleaning
cassette. (p. 76)
• VF BRIGHT is set in the menu system.
m Set it to the center position. (p. 32)
• The camcorder is not malfunctioning.
CCD-TR555E.3-856-784-11 (E,S)
.
.
81
Publicidad
Tabla de contenido
