7
Place the water tray back into the
appliance (fig. n).
8
Place the water tank back into the
appliance (fig. r).
Cleaning the pre-filter
Note
•
If the pre-filter is damaged, worn or
broken, do not use. Visit
www.philips.com/support or
contact the Consumer Care Center
in your country.
Filter alert light
status
F0 displays on the
screen and wick&
pre-filter cleaning
alert
goes on
1
Pull the top part of the back panel
towards you to release it from the
appliance (fig. c).
2
To remove the pre-filter, press the
clip down and pull the filter towards
you (fig. d).
3
Wash the pre-filter under a running
tap. If the pre-filter is very dirty, use
a soft brush to brush away the dust
(fig. ‡).
4
Air dry the pre-filter.
Note
•
Make sure that the pre-filter is
completely dry. If it is still wet,
bacteria may multiply in it and
shorten the lifetime of the pre-filter.
EN
14
Follow this
Clean the pre-
filter
5
After the pre-filter is completely dry,
place it back into the back panel
(fig. h).
6
Touch and hold
reset the pre-filter cleaning time.
Descaling the NanoCloud
rotary humidification
wick
Filter alert light
status
F0 displays on the
screen and wick&
pre-filter cleaning
alert
goes on
1
Pull out the water tank (fig. j).
2
Lift the water tray upwards and pull
it out horizontally (fig. k).
3
Take the wick wheel off the wick
support (fig. †).
4
Soak the NanoCloud rotary
humidification wick in cleansing
agent (e.g diluted white vinegar,
Citric acid solution) for two hours
(fig. ˆ).
Note
•
Please use mid or acid cleanser
•
White vinegar (5% acetic acid)
mix with equal amount of water
•
24g citric acid mix with 4L
water
•
If there are white deposits
(limescale) on the filter, make sure
that the side with the white deposits
is immersed in the water.
•
Do not take the NanoCloud rotary
humidification wick off the wheel
during descaling.
for 3 seconds to
Follow this
Descale the
NanoCloud
rotary
humidification
wick (FY2425)