CycleOps Pro Serie Guía De Usuario página 4

CHAPTER 3: INDOOR CYCLE ASSEMBLY
Attach Stabilizer Feet
A
Rear stabilizer
Front stabilizer
1. Note the difference between the front
and rear stabilizers. The larger stabilizer
with wheels goes in the rear of the indoor
cycle (under the fl ywheel).
Attach Handlebar
1. Remove 6mm bolt in main frame as-
sembly using 6mm Allen wrench. The
6mm bolt can be kept in place of the
large L handle for a more permanent
placement of the handlebar height.
M
Water bottle spacer
I
4. Slide the water bottle spacer onto the
D-shaped tube on the water bottle holder.
B
A
Rear stabilizer
2. Attach the rear stabilizer to the rear of
the main frame with four 5mm stabilizer
bolts and stabilizer washers using the
5mm Allen wrench. Tighten the inner
bolts fi rst, and then proceed to the outer
bolts to ensure the foot is secured prop-
erly and evenly.
Handlebar post
C
Main frame
assembly
2. Insert the handlebar post into the head
tube and secure it by inserting the large L
handle into the main frame assembly on
the right side of the indoor cycle (chain
guard side).
Handlebar
Water bottle holder
5. Slide the water bottle holder and water
bottle spacer onto the handlebar.
A
D
N
Large L
handle
H
M
Water bottle
spacer
I
Water bottle holder
B
Front stabilizer
3. Attach the front stabilizer to the front
of the main frame with four 5mm stabi-
lizer bolts and stabilizer washers using
the 5mm Allen wrench. Tighten the
inner bolts fi rst, and then proceed to the
outer bolts to ensure the foot is secured
properly and evenly.
H
Handlebar
3. Remove two spacer bolts and washers
with 4mm Allen wrench from handlebar.
Handlebar
6. Secure the water bottle holder and
handlebar together using the previously
removed, two 4mm spacer bolts and
washers, on the underside of the handle-
bar.
H
M
Water
I
bottle
spacer
Water
bottle
holder
3