Changing The Belts; Control Pannel; Parts Of The Bending Plate; Inversion Pivot And Angle Selection - Sima STAR 16 Manual De Instrucciones

• Lubricate weekly with calcium grease the holes where the bolts are housed and the bottom of the
bolt to avoid corrosion.
• Review the tension
that which allow a shaft of 1,5 to 2 cm. Fig. 3.
• The reducer group does not need to be grea
• Cables causing breaks or cuts should be urgently changed.
• In case of anomalies in the functioning of the machine, unpl
• At the end of each day, unplug the machine and cover it with a waterproof cloth.
4.1

CHANGING THE BELTS

The machines leave th
the mach ine and by using it for a long time, the belts get loose. To tighten back the belt or replace it, please consider
the following steps.
1. M ake sure the machine is unplugged from the power supply.
2. Remove the back and front doors of the frame of the machine
3. Loosen with a key the four screws (A, Fig.4) just enough for the
4. Depending on what we want to do, tighten or change the belt, we have to deal with the tig
(B, Fig. 4) . When tightening, make sure all belts have the same tension.
5. Once the belts have been tensed, you can fasten back the screws.
6. Place back the inferior frame safeguard.
IMPORTANT: Transmission belts are
of work as these belts can lose their tightness because of temperature and long hours of work.

5. CONTROL PANNEL

A, Fig.5 Switch Plug: e
B, Fig.5 Bending plate direction Selector: It selects the direc
C, Fig.5 Angle adjustment wheel: It is used to regulate the accuracy of the angle that we cannot get
the plate piv ot. Its function is also to advance or retreat the bar mandrill support.
D, Fig.5 Green pilot: The ignited pilot indicates that the machine has g
of rotatio n.
E, Fi g.5 Orange button: we use this button when we release the pedal, push the emergency button or when
an error i n operating the machine happens and we want the bending plate to go back to its point.
F, Fig.5 Emergency stop: It is used to stop the machine in case of emergency.
Pedal. It is used to confirm the rotation of the bending plate. Fig.9

5.1 PARTS OF THE BENDING PLATE

The bending plate has a hole A, Fig
extract th e plate, one hole C, Fig.6 where for the central bolt and a holes sector D, Fig.6 for the inversion pivot.

5.2 INVERSION PIVOT AND ANGLE SELECTION

The inversion pivot (Fig. 8) is used to select the pl
of the belts of the motor each 6 months. The correct tightening of the belt is
e factory with the belts perfectly tightened. It is possible that the installation of
to be checked and if needed tightened after a certain period
lectrical tension entry to the machine.
.6 where to insert the thrust bolt, two twisted holes B, Fig. 6 used to
7
sed as it has already grease inside for it whole life.
ug it and let a technician review it.
.
motor to be displaced.
tion of the rotation of the bending plate.
ot tension and has selected a sense
ate rotation angle.
ENGLISH
htening screws.
with