Solutions To Most Frequent Anomalies; Technical Characteristics; Bending Capacity - Sima STAR 16 Manual De Instrucciones

7. SOLUTIONS TO MOST FREQUENT ANOMALIES

ANOMALY
Cutting/bending power insufficient
The bending plate turns but only stops
after touching the course end.
Faulty tension the machine, the pilot
lamp indicating the state of energy
does not ignite.
The LED is on but the machine does
not work.
230V or 400V connection. It is regular
but the machine would not run.
During regression and after bending,
the bending plate does not stop at the
starting point.

8. TECHNICAL CHARACTERISTICS

MODEL MOTOR
POWER
STAR-16 1,5Kw

9. BENDING CAPACITY

Resistance of the Nº of bars Ø6
steel bars o 1/4"
R-480 N/mm²
R-650 N/mm²
Doblado con
mandril de Ø
POSSIBLE CAUSE
Loose or damaged belts
Power drop in motor
Defect end of course
Defect electrical connection.
Check switch board at work place
The machine is not well connected
Unstable tension
End of course
MOTOR NET WEIGHT
TENSION
230v / 400v
Nº of bars Ø8
o 5/16"
7 6
7 6
18 24
Tighten belts or change
Let the technical service check the
motor
Check the stopping course end and
confirm its
closed). Substitute it in case of defect
Check there is tension in the
workplace. Check the high and low
tension fuses of the machine switch
board. Check the connection of the
cables.
The machine is connected by one
phase. Check the high tension fuses
of the machine switch board and that
of
connection of the cables in the switch
board, base and the plug.
Check emission stream exit. If the
voltage is inferior to 230V or 400V the
machine
recommended then to used a tension
stabiliser.
Check the end of course and its
continuity (1 open 0 closed).
DIMENSIONS LxAxH
mm
140 Kg. 1136x738x1095
Nº of bars Ø10 Nº of bars Ø12
o 3/8"
5
5
36
9
SOLUTION
continuity. (1 open, 0
the work place. Check
will not run.
ROTATION/MIN.
19
Nº of bars Ø16
o 1/2" o 5/8"
3 1
2 1
36 48
ENGLISH
the
It is