Indesit KN3G2/EX Manual De Instrucciones página 8

Start-up and use
Using the hob
GB
Lighting the burners
For each BURNER knob there is a complete ring showing
the strength of the flame for the relevant burner.
To light one of the burners on the hob:
1. Bring a flame or gas lighter close to the burner.
2. Press the BURNER knob and turn it in an
anticlockwise direction so that it is pointing to the
maximum flame setting .
3. Adjust the intensity of the flame to the desired level
by turning the BURNER knob in an anticlockwise
direction. This may be the minimum setting , the
maximum setting
If the appliance is fitted with an electronic lighting
device* (C), simply press the BURNER knob and turn it
X
longer period of time.
! If the flame is accidentally extinguished, switch off the
burner and wait for at least 1 minute before attempting
to relight it.
If the appliance is equipped with a flame failure safety
device* (X), press and hold the BURNER knob for
approximately 2-3 seconds to keep the flame alight
and to activate the device.
To switch the burner off, turn the knob until it reaches
the stop position •.
Practical advice on using the burners
For the burners to work in the most efficient way
possible and to save on the amount of gas consumed,
it is recommended that only pans that have a lid and
a flat base are used. They should also be suited to the
size of the burner.
Burner
Fast (R)
Semi Fast (S)
Auxiliary (A)
*
Only available in certain models.
8
or any position in between the two.
in an anticlockwise direction
so that it is pointing to the
maximum flame setting, until
the burner is lit. The burner
may be extinguished when
the knob is released. If this
occurs, repeat the operation,
C
holding the knob down for a
ř Cookware diameter (cm)
24 - 26
16 - 20
10 - 14
To identify the type of burner, please refer to the
diagrams contained in the "Burner and nozzle
specifications".
Electric hotplates*
The corresponding knob may be turned clockwise or
anti-clockwise and set to six different positions:
Setting Normal or Fast Plate
0
Off
1
Low
2 - 5
Medium
6
High
When the selector knob is in any position other than the
off position, the 'on' light comes on.
Using the oven
! The first time you use your appliance, heat the empty
oven with its door closed at its maximum temperature
for at least half an hour. Ensure that the room is well
ventilated before switching the oven off and opening
the oven door. The appliance may emit a slightly
unpleasant odour caused by protective substances
used during the manufacturing process burning away.
! We recommend cleaning the oven before using it for
the first time, following the instructions provided in the
„Care and maintenance" section.
! Before operating the product, remove all plastic film
from the sides of the appliance.
! Never put objects directly on the bottom of the oven;
this will avoid the enamel coating being damaged.
Only use position 1 in the oven when cooking with the
rotisserie spit.
Lighting the oven
To light the oven burner, bring a flame or gas lighter
close to opening F (see fi gure) and press the OVEN
control knob while turning it in
an anticlockwise direction until
it reaches the MAX position.
If the appliance is fitted with an
electronic lighting device* (see
F
fi gure), press the OVEN knob
and turn it in an anticlockwise
direction, towards the MAX
position, until the burner is lit.