Brentwood Appliances MPI-59B Manual Del Usuario página 6

4. Slowly pour the water into the reservoir using the special measure
and taking care not to go over the maximum level (about 170ml)
indicated by "MAX" on the reservoir.
Selecting the Temperature:
1. Put the iron in a vertical position.
2. Put the plug in the socket.
3. Adjust the temperature knob (H) according to the international
symbol on the garment label [Fig. 3]. The power light (E) indicates
with a red light that the iron is heating up. Wait until the power
light turns green before ironing.
Warning: during ironing, the power light comes on at intervals,
indicating that the selected temperature is maintained. If you lower the
selected temperature after ironing at a high temperature, do not start
ironing until the power light comes on again.
Selecting the Steam:

The quantity of steam is regulated by the steam knob (B).
1. Turn the steam knob to a position between minimum and maximum
depending on the quantity of steam required and the temperature
selected.
Warning: the iron gives off steam continuously only if you hold the iron
horizontally. You can stop the continuous steam by placing the iron in a
vertical position or by moving the steam knob to "O". As indicated on the
steam knob (H) and in the initial table, you can only use steam at the
highest temperatures. If the selected temperature is too low, water may
drip onto the plate.
Selecting Shot-Steam and Steam when Ironing Vertically:
1. Press the shot-steam button (C) to generate a powerful burst of
steam that can penetrate the fabrics and smooth the most difficult
and tough creases. Wait for a few seconds before pressing again [Fig.
4].
2. By pressing the shot-steam button at intervals you can also iron
vertically (curtains, hung garments, etc.) [Fig. 5].
Warning: the shot-steam function can only be used at high temperatures.
Stop the emission when the power light comes on, and then start ironing
again only after the light has gone off.
DRY IRONING
To iron without steam, follow the instructions in section "Steam Ironing",
leaving the steam selector (B) on position "O".
SPRAY FUNCTION
1. Make sure that there is water in the reservoir.
2. Press the spray button (D) slowly (for a dense spray) or quickly (for a
6