Inspect Engine Spark; Inspect Muffler And Spark Arrestor; Inspect Spark Arrestor Screen (If Equipped); Storage - Generac Small Pro Power Washer El Manual Del Propietario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

NOTE: Replace spark plug if electrodes are
pitted, burned or porcelain is cracked. Use
ONLY recommended replacement plug. See
Product Specifications Sheet.
4. Install spark plug finger tight, and tighten
an additional 3/8 to 1/2 turn using spark
plug wrench.

Inspect Engine Spark

WARNING
Accidental Start-up. Disconnect spark plug wire
when working on unit. Failure to do so could result
in death or serious injury.
1. Disconnect spark plug wire from spark
plug.
2. Secure spark plug wire where it cannot
contact spark plug.
3. Test spark plug with approved spark plug
tester.
NOTE: DO NOT inspect for spark with spark
plug removed.

Inspect Muffler And Spark Arrestor

NOTE: It is a violation of California Public
Resource Code, Section 4442, to use or
operate the engine on any forest-covered,
brush-covered, or grass-covered land unless
the exhaust system is equipped with a spark
arrestor, as defined in Section 4442, maintained
in effective working order. Other states or
federal jurisdictions may have similar laws.
NOTE: Call 1-888-GENERAC (1-888-436-
3722)
with
questions
replacement.
NOTE:
Use
ONLY
replacement parts.
Inspect muffler for cracks, corrosion, or other
damage. Remove spark arrestor, if equipped,
inspect for damage or carbon blockage. If
replacement parts are required.
Inspect Spark Arrestor Screen
(if equipped)
WARNING
Hot Surfaces. When operating machine, do not
touch hot surfaces. Keep machine away from
combustibles during use. Hot surfaces
could result in severe burns or fire.
1. See
Figure
4-11. Loosen fasteners (A) and
remove heat shield from muffler.
2. See
Figure
4-12. Loosen fasteners (B) and
remove spark arrestor from muffler.
3. Inspect spark arrestor. Replace if torn,
perforated or otherwise damaged.
Spark Arrestor P/N 0K1851
Owner's Manual for Power Washer
(000102)
about
component
original
equipment
(000108)
Maintenance and Troubleshooting
4. If screen is not damaged, clean it with a
commercial solvent and replace.
A
Figure 4-11. Heat Shield Fasteners
B
Figure 4-12. Spark Arrestor Fasteners

Storage

General

DANGER
Explosion and Fire. Fuel and vapors are
extremely flammable and explosive. Add fuel
in a well ventilated area. Keep fire and spark
away. Failure to do so will result in death
or serious injury.
WARNING
Risk of Fire. Verify machine has properly
cooled before installing cover and storing
machine. Hot surfaces could result in fire.
• DO NOT place a storage cover on a hot
power washer. Allow unit to cool to room
temperature before storage.
• DO NOT store fuel from one season to
another unless properly treated.
• Replace fuel container if rust is present.
Rust in fuel will cause fuel system
problems.
• Cover unit with a suitable protective,
moisture resistant cover.
• Store unit in a clean and dry area.
• Always store power washers and fuel away
from heat and ignition sources.
A
000135
000136
(000105)
(000109)
13

Publicidad

Tabla de contenido
loading

Tabla de contenido