Weight Limit Function (+/-) - Gram S3 Serie Manual De Utilización

To access to memory database and change one position, press and hold
Scale will show "CLU XX", where XX is the memory position.
Use and
to move the digit on the right or the left. When setting desired memory position,
press to confirm it.
Scale from now will be programmed with the set piece counting memory.
We can start piece counting placing pieces on the counting plate or in a
recipient if we use tare function.

weight limit function (+/-)

This function is suitable to classify a list of products by weight, ruling out
those that are under or over the desired min or max weight.
Scale shows a bar with negative left extreme, and positive right extreme, and
in the center the accepted products.
This figure indicates if each product is in the desired range set. It uses a
beep as acoustic signaling. We offer a relay card to connect external advice
22
to increase and decrease the flashing digit, use
.
or