Auto Tare Function; Stability Filter - Gram S3 Serie Manual De Utilización

To enable function, press
"AUt-t 0".
to modify the value at the right of "1" to enable function.
Use
Confirm pressing

Auto Tare Function

When display is showing zero and without any object over the plate, place the
empty recipient or box over the plate.
Scale will show zero and automatically will operate Tare function, showing
"0" value and turning on scale tare symbol on display.
Place the object in the box, and scale will show net weight. (object weight).
If you remove all from the plate, scale will cancel tare and indicate again "0".
Now, we can do the same operation again with no limit. Scale will always
operates tare automatically still we unable this function.

Stability filter

In adverse environmental conditions, or when scale is used in instable
weightings, you can increase the weighting stability with filters.
To access this function, press
still display shows "fiLTEr". Press
digit on the right, in accordance with the following table:
filter 0 - Originally programmed in Factory (Do not use if you do not know)
filter 1 - Stable environments (fast response)
30
and then press
and escape pressing
and display will show "PLU XX". Press
several times still it shows
.
to confirm, and display will show a