Descargar Imprimir esta página

Functional Description; Depth Adjustment - Makita 6827 Manual De Instrucciones

Ocultar thumbs Ver también para 6827:

Publicidad

Idiomas disponibles

Idiomas disponibles

SAVE THESE INSTRUCTIONS
WARNING:
MISUSE or failure to follow the safety
rules stated in this instruction manual
may cause serious personal injury.
SYMBOLS
The followings show the symbols used for tool.
V............................volts
A ...........................amperes
Hz..........................hertz
....................alternating current
.......................no load speed
.......................Class II Construction
.../min....................revolutions or reciprocation per
minute

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
unplugged before adjusting or checking function on
the tool.

Depth adjustment

2
3
When you wish to drive self drilling screws, etc., adjust
the depth as follows. Turn the locator to adjust the depth.
Initially, adjust the locator to create a distance of approxi-
mately 1 mm (3/64") from the tip of the front cap (which
works in conjunction with the locator) to the base of the
screw head. One full turn of the locator equals 1 mm (3/
64") change in depth.
After adjusting the locator, turn the adjusting ring so that
the 6" mark is aligned with the pointer on the gear hous-
ing. Drive a trial screw into your material or a piece of
duplicate material. If the depth is not suitable for the
screw, continue adjusting until the proper depth setting is
obtained.
USD201-2
002614
1. Pointer
1
2. Locator
3. Front cap
4. Adjusting ring
4
1mm (3/64")
1mm (3/64")
Switch action
1
CAUTION:
Before plugging in the tool, always check to see
that the switch trigger actuates properly and returns
to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Tool speed
is increased by increasing pressure on the switch trigger.
Release the switch trigger to stop.
For continuous operation, pull the switch trigger and then
push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
NOTE:
Even with the switch on and motor running, the bit
will not rotate until you fit the point of the bit in the
screw head and apply forward pressure to engage
the clutch.
4
002622
002623
002628
1. Switch trigger
2. Lock button
2

Publicidad

loading