Replacing The Joystick Potentiometers - NAMCO WORLD KICKS Manual De Instrucciones

8-7

Replacing the Joystick Potentiometers

1. Remove the Joystick Assembly.
2. Remove 4off pozi head self tapping screws and remove the potentiometer
bracket complete with potentiometer.
Group rider
Vertical direction
potentiometer
Hex pozi head
self tapping screw
3. Remove the set screw using the hex wrench (diagonal
remove the group follower. (The diagram below shows the horizontal direction
potentiometer, but the vertical direction potentiometer can be removed in the
same way).
4. Remove the potentiometer nut, washer, spacer and bracket.
Potentiometer nut
Set screw
Group follower
5. Replace the potentiometer and reassemble in reverse order.
•
When replacing the Group Follower or Group Rider, ensure that the set screw
engages on the flat of the potentiometer shaft.
•
When refitting the horizontal direction potentiometer, align the universal joint with
the grooves in the group follower and joystick.
After replacing, always check the operation and settings.
(see 8-6 page 67)
Horizontal direction
potentiometer
Group follower
Spacer
Washer
Potentiometer bracket
Page 69
Hex pozi head
self tapping screw
Potentiometer bracket
Universal joint
1 / inch) supplied, and
16
Potentiometer
(see 6-2-3 (d) page 51)