Publicidad
Idiomas disponibles
Idiomas disponibles
en
8
Extension cable.
If the use of an extension cord
WARNING
is required, its length and con-
ductor cross-section must be adequate for the
application in order to prevent a voltage drop
in the extension cord, power loss and over-
heating of the power tool. Otherwise, the
extension cable and power tool are prone to
electrical danger, and the working efficiency is
decreased.
Intended use of the power tool:
Hand-guided oscillator for use without water
supply in weather-protected environments
using the application tools and accessories
recommended by FEIN.
– for sawing wood, plastic, glass-fibre rein-
forced plastics (GFRP, CFK) and for sawing
sheet metal (max. 1 mm)
Operation of the power tool off power generators.
This power tool is also suitable for use
with AC generators with sufficient power
output that correspond to the Standard
ISO 8528, design type G2. This Standard is
particularly not complied with when the so-
called distortion factor exceeds 10 %. When
in doubt, please refer to the generator
instruction/specification guide.
Recommended dimensions of extension cords
at an operating voltage of 120 V – single-
phase a. c., with only MM700MAX (**) con-
nected:
Max. cable length, ft
≤ 100
100
–200
–300
Min. conductor size
A.W.G.
16
14
– for removing tile joints and rasping or
scraping off tile grout or carpet remainders
– for cutting elastic sealants (silicone or
acrylic) on facades/frontages and for
roughing groove faces
– for sanding or rasping of smaller surfaces
Operating the power tool off
WARNING
power generators whose no-
load speed exceeds the voltage value on the
type plate of the power tool is prohibited.
Max. cable length, m
200
≤ 30
30
– 60
Min. conductorcross-
2
section, mm
12
1.5
2.5
60
–100
4
Publicidad
