Craftsman 580.750901 Manual Del Operador página 8

6. Attach bottle bracket (A) to handle with carriage bolt (B)
and black plastic knob (C). Tighten by hand.
@
Attach Project Pro@ PerfectMix
TM
Siphon to
Attach the tube end of the blue PerfectMix
TM
Siphon (t}) to
the barbed tube fitting (E) on the pump.
Attach PerfectNix
TM
Detergent Siphon to
Concentrategettie
Place PerfectMix
TM
bottle (not included) in the wire-form
bracket on the handle. Remove cap from bottle and insert the
PerfectMix
TM
Siphon. Screw the siphon unit to the top of the
bottle (F). Use the clip on the cap (G) to snap siphon to wire
form bracket when siphon is not in a concentrate bottle.
Add Engine 0it
1. Place pressure washer on a fiat, level surface.
2. Cleanarea around oil fill and remove yellow oil fill
cap/dipstick.
3. Hold neck of supplied oil pouch and remove cap.
4. Slowly pour contents of oil pouch into oil fill opening.
Checking oil level frequently, fill to FULL mark (top hob)
on dipstick.
I Full
NOTICE Pauseto permit oil to settle. Wipe dipstick clean
eachtime oil level is checked. DONOT overfill.
NOTICE improper treatment of pressure washer could
damage it and shorten its life.
, DO NOT attempt to crank or start the engine before it has been
properly serviced with the recommended oil. This could result in
an engine failure.
5. Replaceoil fill cap/dipstick and fully tighten.
Add Fuel
Fuel must meet these requirements:
* Clean,fresh, unleaded gasoline.
* A minimum of 87 octane/87 AKI (91 RON). For high
altitude use, see High Altitude.
° Gasolinewith up to 10% ethanol (gas@@ is acceptable.
NOTICE Use of unapproved fuels could damage pressure
washer and voids warranty.
DO NOT use unapprovedgasoline such as E15and E85.
DO NOTmix oil in gasolineor modify engineto run on alternatefuels.
,a, WARNING Fuel and its vapors are extremely flammable
and explosive which could cause burns,
fire or explosion resulting in death or
serious injury.
WHENADDING FUEL
Turn pressure washer engine OFFand let it cool at least 2
minutes before removing fuel cap. Loosen cap slowly to relieve
pressure in tank.
Fiii fuel tank outdoors.
* DO NOT overfill tank. Allow spacefor fuel expansion.
oif fuel spills, wait until it evaporatesbefore starting engine.
Keepfuel away from sparks, open flames, pilot lights, heat, and
other ignition sources.
Checkfuel lines, tank, cap and fittings frequently for cracks or
leaks. Replaceif necessary.
DO NOT light a cigarette or smoke.
To protect the fuel system from gum formation, mix in a fuel
stabilizer when adding fuel. See Storage. All fuel is not the
same. if you experiencestarting or performance problems
after using fuel, switch to a different fuel provider or change
brands. This engine is certified to operate on gasoline. The
emission control system for this engine is EM (Engine
Modifications).
1. Clean area around fuel fill cap, remove cap.
2. Slowly add regular unleaded fuel (H) to fuel tank (S). Be
careful not to overfill. Allow about 1.5" (4 cm) (K) of tank
space for fuel expansion.