Assembly And Adjustments - Hitachi C 10RB Manual De Instrucciones

ASSEMBLY AND ADJUSTMENTS

ASSEMBLE THE TABLE SAW TO THE STAND
(Fig. A)
1. Unfold the leg sets and push down in place.
2. Place the stand on a level surface and adjust the
front-right adjustable foot, so all legs are contacting
the floor and are at similar angles on the floor.
3. Match the holes of the stand to the holes on the
bottom flange of the saw base.
4. Fasten the saw to the stand using the four handle (1)
then tighten securely .
5. Position the saw on a clean, level surface.
Fig. A
ASSEMBLE THE HANDWHEEL HANDLE (FIG. B)
Thread the handwheel handle (1) into the handwheel
hole (2), and then tighten the nut against the handwheel
with a 10mm wrench. NOTE: If the handle bolt becomes
loose, remove the plastic end cap and this will allow you
to tighten securely.
Fig. B
BLADE GUARD ASSEMBLY (FIG. C, D)
To avoid injury from an accidental start, make sure
the switch is in the OFF position and the plug is
disconnected from the power source outlet.
• When installing the blade guard, cover the blade
teeth with a piece of folded cardboard to protect
yourself from possible injury.
• Never operate this machine without the safety
guard in place for all through sawing operations.
1
Installing the blade guard assembly (Fig. C)
1. Remove the table insert.
2. With the blade elevation handwheel (1), raise the
blade to the maximum height.
3. Loosen the blade lock handle (2) do not pull on
handle just turn and move the handwheel (1) to 45°
on the bevel scale.
4. Tighten the bevel lock handle.
5. Locate the splitter assembly mounting bracket (3) at
the rear of the blade.
6. Cover the blade teeth with a folded cardboard or
position the plastic blade guard over the blade to
protect your hands.
7. Place the two kickback pawls (4) toward the rear of
the table, and align the splitter mounting holes to the
holes in the bracket.
8. Place the flat washers onto the blade guard lock bolt
and thread the bolt (5) into the the mounting hole, then
tighten securely.
9. Return the blade to 90º and replace the table insert.
– 11 –
2
1
WARNING
English