Hitachi C 10RB Manual De Instrucciones página 22

English
Attach auxiliary fence to rip fence with two "C"
clamps. (Fig. DD)
Fig. DD
DADO CUTS (FIG. EE)
1. The dado blade insert is included with this saw.
Remove the saw blade, original table inser and blade
guard. Install the dado and dado blade insert.
2. Instruction for operating the dado is packed with the
separately purchased dado set.
3. The arbor (1) on this saw restricts the maximum
width of the cut to 13/16".
4. When making full 13/16" dado cuts, it is not
necessary to install the outside flange (2) before
screwing on the arbor nut (3). Make sure that the
arbor nut (3) is tight, and that at least one thread of
the arbor sticks out past the nut.
5. Do not exceed 8" diameter dadoes and keep the
width 13/16" or less. It will be necessary to remove
the blade guard and splitter when using a dado
blade. Always use caution when operating a dado
blade.
6. Use only the correct number of round outside blades
and inside chippers as shown in the dado set's
instruction manual. Blade or chipper must not exceed
13/16".
7. Check saw to ensure that the dado will not strike the
housing, insert, or motor when in operation.
WARNING
For your own safety, always replace the blade, blade
guard assembly, and blade insert when you are
finished with the dado operation.
Fig. EE
– 22 –
2
1
3