Important - Hitachi C 10RB Manual De Instrucciones

English
NOTE: Make sure the "anti-kick back pawls do not get
caught between the insert and the guard, but rest on top
of the insert.
Fig. C
2
1
Removing the blade guard assembly (Fig. C)
WARNING
To avoid injury from an accidental start, make sure
the switch is in the OFF position and the plug is
disconnected from the power source outlet.
1. Remove the table insert.
2. With the blade elevation handwheel (1), raise the
blade to the maximum height.
3. Loosen blade lock handle (2) do not pull on handle
just turn and move the handwheel (1) to 45° on the
bevel scale.
4. Tighten the bevel lock handle.
5. Cover the blade teeth with a piece of folded
cardboard or position the plastic blade guard over the
blade to protect your hands.
6. Loosen the nut (5) and remove the blade guard
assembly, then retighten the nut.
7. Return the blade to 90° and replace the table insert.
NOTE: When took off the insert, and rise the blade, kick
back pawl will snap in the hole on the table and can not
take off. Make sure the insert is assembled before rising
the blade.
ALIGNING THE BLADE GUARD SPLITTER (FIG. D)
WARNING
To avoid injury from an accidental start, make sure
the switch is in the OFF position and the plug is
disconnected from the power source outlet.
• When installing the blade guard, cover the blade
teeth with a piece of folded cardboard to protect
yourself from possible injury.
• Never operate this machine without the safety guard
in place for all through sawing operations.
IMPORTANT: The splitter must always be correctly
aligned with the blade so the cut workpiece will pass on
either side without binding or twisting.
3
1. Remove the table insert and raise the blade to the
maximum height by turning the blade elevation
5
handwheel clockwise.
2. Lift the blade guard and position it toward the rear of
the table.
3. Adjust the blade to the 90° vertical position by
4
unlocking the blade tilting lock knob and turning the
bevel tilting handwheel counterclockwise, and then
lock into position.
4. To see if the blade (1) and splitter (2) are correctly
aligned, lay a combination square along the side of
the blade and against the splitter (making sure the
square is between the teeth of the blade).
5. Tilt the blade to the 45° position and check the
alignment again.
6. If the blade and splitter are not correctly aligned:
a. Remove the blade guard by removing the
b. Loosen and remove the two bolts (3) from the
7. Place two spacers (4) on the guard mounting bracket
(attached to the saw). Position them over the
corresponding mounting bolt holes (refer to step 6-b)
after removing the adhesive backing affixed to the
washers.
8. Replace the two guard mounting bolts (3) and tighten
securely. Also reattach the blade guard assembly,
affixing it to the machine by its' corresponding wing
bolt.
9. Check the splitter and blade alignment again at both
90° and 45°.
10.Add or remove the spacers until the alignment is
correct.
11.Replace the table insert.
Fig. D
1
– 12 –
wing bolt that locks the guard in place.
mounting bracket (5).
5
4
2
3