Rearpanel; Installation; Operation; Setup - Omnitronic CDP-360 Manual Del Usuario

4.3 Rearpanel

21. AC CONNECTION
22. VOLTAGE SELECTOR
Make sure that the indication corresponds to the available voltage.
23. REMOTE CONTROL
Connect the controller via these plugs. Make sure that you connect the player Unit 1 to the controller Unit 1
and the player Unit 2 to the controller Unit2.
24. AUDIO OUTPUT
Each player and each channel has an output jack. Connect the output to the respective input of your mixer
only.

5. INSTALLATION

Install the CD-player on a plane surface or in your rack.
Make sure that the inclination angle will not exceed 15°, as the CD cannot be read correctly otherwise.
Rack-installation: This CD-player is built for 19" racks (483 mm). The rack you use should be a Double-Door-
Rack where you can open the frontpanel and the rear panel. The rack should be provided with a cooling fan.
When mounting the CD-player into the rack, please make sure that there is enough space around the device
so that the heated air can be passed on. Steady overheating will damage your device.
You can fix the CD-player with four screws M6 in the rack.
Be aware that fastening the device with four screws on the front panel is not enough. In order to ensure
safety, additional fastening by using ground and side bars is necessary.
CAUTION: Make sure that the CD-player is switched off (power-switch in outer position) before you connect
it to the mains in order to avoid damages on your loudspeakers.
Connect the CD-player with the RCA-cable to your mixer via the Audio Out-sockets. Make sure that the
right/left occupation (plug-colour red/white) is the same at both devices.
Make sure that the indication on the Voltage-selector corresponds to the available voltage in order to avoid
severe damages.
Connect your CD-player with the mains.

6. OPERATION

6.1 Setup

Switch the CD-player on via the Power-switch.
When the device is on and the tray has no disc, "NO DISC" appears on the display.
20/46 10602250_V_1_2.DOC