Home Decorators Collection 56012 Guía De Uso Y Cuidado página 7

Assembly - Standard Ceiling Mount
1
Preparation for standard mounting
□
Remove the canopy ring (GG) by turning the ring clockwise
until it unlocks.
□
Remove the mounting bracket (A) from the canopy (C) by
loosening the two canopy screws (EE) located in the "L
shaped" slots.
□
Remove and save the two canopy screws (FF) in the round
holes. This will enable you to remove the mounting bracket (A).
EE
3
Assembling the fan
CAUTION: To ensure wobble-free operation and to
avoid damage to the fan, the downrod (B) and the
setscrew (JJ) must be completely tightened.
NOTE: This fan is equipped with a safety tab (II). Should
the setscrew (JJ) ever become loose while the fan is
running in reverse, the safety tab (II) will engage and
stop the fan from falling.
□
Loosen, but do not remove, the setscrew (JJ) on the collar
(HH) on top of the fan-motor assembly (E).
□
Install the downrod (B) by inserting it into the motor collar
(HH), and turning it clockwise until it is tight.
□
Re-tighten the setscrew (JJ) on the collar (HH) on top of the
fan motor assembly (E).
2
Routing the wires
□
Route the wires exiting the top of the fan-motor assembly
(E) through the canopy ring (GG).
□
Insert the ball/downrod (B) through the canopy (C) and
slide the decorative motor collar cover (D) onto the end of
the ball/downrod (B). Make sure the slots on the canopy
(C) are on top.
□
Route the wires exiting the top of the fan motor assembly
(E) through the downrod as shown.
A
FF
C
GG
7
JJ
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
C
GG
B
D
E
B
II
HH
E