Home Decorators Collection 56012 Guía De Uso Y Cuidado página 8

Assembly - Close-to-Ceiling Mount
1
Close-To-Ceiling Mounting
□
Remove the canopy ring (GG) from the canopy (C) by
turning the ring clockwise until it unlocks.
□
Remove the mounting bracket (A) from the canopy (C) by
loosening the two canopy screws (EE) located in the "L
shaped" slots.
□
Remove and save the two canopy screws (FF) in the
round holes. This will enable you to remove the mounting
bracket (A).
□
Remove the decorative canopy bottom cover (KK) from the
canopy (C) by pressing the three studs.
EE
2
Routing the wires
□
Remove three of the six screws and lock washers (LL)
(every other one) securing the motor collar (HH) to the
top of the fan motor housing (E).
□
Route the wires exiting the top of the fan-motor
assembly (E) through the rubber gasket (CC) aligning
the holes in the rubber gasket (CC) with the three
screw holes in the fan-motor assembly (E).
□
Route the wires exiting the top of the fan-motor
assembly (E) through the canopy ring (GG), and
the canopy (C) (make sure the slot openings for
the canopy ring and canopy are on top). Place the
canopy (C) over the collar (HH) at the top of the motor
assembly (E).
A
□
Align the mounting holes with the holes in the
motor (E) and fasten, using the three screws and
lock-washers (LL) removed previously. Tighten the
mounting screws securely.
FF
C
LL
KK
GG
GG
8
C
CC
HH
E