Statement For Radio; Specifications For Radio; Fcc Statement; Ic(Ised) Statement - Stanley NB08PT-18 Traducción A Partir De Instrucciones Originales

8. STATEMENT FOR RADIO

This equipment complies with CE radiation exposure requirement set forth for an uncontrolled environment.
End users must follow the specific operating instructions for satisfying RF exposure compliance.
8.1

SPECIFICATIONS FOR RADIO

This tool has a RF module (ESP32-WROOM-32 by Espressif, FCC code: 2AC7Z-ESPWROOM32, IC code:
21098-ESPWROOM32) and it operates with the conditions below.
Wi-Fi : 2,412MHz~2,472MHz, 13dBm, DSSS and OFDM
Bluetooth : 2,402MHz~2,480MHz, 4dBm
A printed antenna with 2dBi gain which is integrated in the RF module(ESP32-WROOM-32).
Oscillator: RF: 40MHz, Screen module: *25MHz(for MC), 32.768kHz(for RTC)
*25MHz is multiplied to 180MHz maximum in the CPU.
8.2

FCC STATEMENT

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference and
(2) this device must accept any interference received, including interference that may cause undesired opera-
tion.
Any changes or modifications not expressly approved by the party responsible for compliance could void your
authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful inter-
ference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. To
maintain compliance with FCC RF exposure compliance requirements, avoid direct contact to the transmitting
antenna during transmitting.
8.3

IC(ISED) STATEMENT

This device complies with Industry Canada's licence-exempt RSSs. Operation is subject to the following two
conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of
the device.
This EUT complies with SAR for general population/uncontrolled exposure limits in IC RSS-102 and had been
tested in accordance with the measurement methods and procedures specified in IEEE 1528 and IEC 62209.
This equipment should be installed and operated as far as possible from the user body or set the device to
lower output power if such function is available.
E N G L I S H
23