Quick Installation - Tripp-Lite SmartPro 3U Manual Del Propietário

201112103 93-2459.qxd

Quick Installation

Plug the UPS into an outlet on a
1
dedicated circuit.*
NOTE! after you plug the UPS into a live AC outlet,
the UPS (in "Standby" mode) will automatically
charge its batteries,** but will not supply power to
its outlets until it is turned ON (see Step 3 below).
* Select models include an additional plug which can be switched by
a qualified electrician. ** The BATTERY CHARGE LED will be the
only LED illuminated.
Plug your equipment into the UPS.*
2
* Your UPS is designed to support only electronic equipment. You will
overload the UPS if the total VA ratings for all the equipment you
connect exceeds the UPS's Output Capacity. To find your equipment's
VA ratings, look on their nameplates. If the equipment is listed in
amps, multiply the number of amps by 120 to determine VA. (Example:
1 amp × 120 = 120 VA). If you are unsure if you have overloaded the UPS's
outlets, see "OUTPUT LOAD LEVEL" LED description.
Turn the UPS ON.
3
Press and hold the "ON/OFF/STANDBY" button for
one second. The alarm will beep once briefly after one
second has passed. Release the button.
1/9/2012 12:21 PM Page 4
4
1
2
3