Battery Replacement - Tripp-Lite SmartPro 3U Manual Del Propietário

201112103 93-2459.qxd

Battery Replacement

Battery replacement should be performed only by authorized service personnel using the same
number and type of batteries (sealed Lead-Acid). Under normal conditions, the original batteries in
your UPS will last many years. See Safety section before replacing batteries. The batteries are
designed for hot-swap replacement (i.e. leaving the UPS in ON mode), but some qualified service
personnel may wish to put the UPS in the OFF mode and disconnect equipment before proceeding.
Procedure
Remove Front Panel and Battery Holding Plate
1
Disconnect Batteries
2
Remove/Dispose of Batteries
3
Add Batteries
4
Connect Batteries
5
Attach connectors: black-to-black and red-to-red.
Replace Front Panel
6
WARNING! Batteries can present a risk of
electrical shock and burn from high short-
circuit current resulting in serious injury or
death. Battery terminals are in close
proximity to UPS cabinet and special care
must be taken to avoid shorting the batteries
including not touching metal cabinet and
battery terminals simultaneously.
FCC RADIO/TV INTERFERENCE NOTICE: (FOR CLASS A MODELS)
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with
the instruction manual, may cause interference to radio communications. Operation of this equipment is likely to cause harmful interference in which case the user will be required to correct the interference
at his own expense. The user must use shielded cables and connectors with this product. Any changes or modifications to this product not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Regulatory Compliance Identification Numbers
For the purpose of regulatory compliance certifications and identification, your Tripp Lite product has been assigned a unique series number. The series number can be found on the product name-
plate label, along with all required approval markings and information. When requesting compliance information for this product, always refer to the series number. The series number should not be
confused with the marking name or model number of the product.
Tripp Lite follows a policy of continuous improvement. Product specifications are subject to change without notice.
Note on Labeling
Two symbols are used on the label.
V~ : AC Voltage
V : DC Voltage
1/9/2012 12:21 PM Page 12
12
1

2

3
6
5
4