Assembly; Assembling The Blow Pipe And Control Handle - Husqvarna 130BT Manual De Instrucciones

Assembling the blow pipe and
control handle
• Connect the blower and control pipe with the flexible
hose. Clamp both ends of the flexible hose in place.
Use the accompanying hardware.
1
3
1 Flexible hose
2 Control pipe
3 Clamp
4 Clamp
NOTE!
Lubricate the pipes a little to facilitate assembly.
• Fasten the handle holder to the control pipe and
tighten the screw on the holder. Please make sure to
align the handle holder with the convex of the control
pipe.
• The cabling of the throttle handle must not be twisted
during assembly.
• Adjust the position to achieve a comfortable working
position. and tighten.
• Fasten the cabling at the centre of the hose using a
clamp. Use the clamp to fasten the colgate tube
containing the throttle cable and the power cable to
the hose.

ASSEMBLY

2
4
Blow pipe
Assemble the intermediate pipe and the blow pipe. It is
possible to add more intermediate pipes if longer blow
pipes are required.
Optional equipment
(Not included in the box).
• If higher air speed is required, the round blow pipe is
replaced by the flat nozzle.
–
English 13