Connecting Cables; Digital Connection - Eizo FlexScan S1932 Manual Del Usuario

Prior to use

Connecting Cables

Attention
• When replacing the current monitor with a S1932 monitor, be sure to change the PC settings for
resolution and vertical frequency to those which are available for the S1932 monitor referring to the
resolution table (back of cover page) before connecting the PC.
NOTE
• When connecting two PCs to the monitor, refer to the User's Manual on the CD-ROM.
1
Check that the monitor and the PC are powered off.
2
Connect the monitor to the PC with a signal cable that matches the connectors.
After connecting the cable connectors, tighten the screws of the connectors to secure the coupling.
Connectors on
the PC
Audio output
connector
DVI connector
USB Downstream
Connectors on
the PC
Audio output
connector
D-Sub mini 15-pin
connector
USB Downstream
* Required to use the speaker of the monitor (page 6).
1
* Required when performing the monitor adjustments using the ScreenManager Pro for LCD software. (Refer to
2
the User's Manual on the CD-ROM.)
3
Plug the power cord into a power outlet and the Power connector on the monitor.
4
Installation

Digital connection

CD player, etc
Stereo mini jack cable (supplied)*
Signal cable FD-C39 (supplied)
EIZO USB cable MD-C93 (supplied)*
Analog connection
CD player, etc
Stereo mini jack cable (supplied) *
Signal cable MD-C87 (supplied)
EIZO USB cable MD-C93 (supplied) *
Setting/Adjustment
1
2
1
2
Troubleshooting
Connectors on
the monitor
Audio input
connector
DVI-D connector
USB Upstream
Connectors on
the monitor
Audio input
connector
D-Sub mini 15-pin
connector
USB Upstream