Assembly, Steps 10,11 - HAMPTON BAY 80434/25MM4495-PB84 Guía De Uso Y Cuidado

Assembly (continued)
10
Door installation
Locate Right Front Door (M) and Left Front Door (L)
and slide door hinge keyhole into panel hinge bracket.
(Diagram 1)
Use a Phillips Head Screwdriver to tighten screws.
(Diagram 2)
TO ADJUST HINGES:
To adjust door forward or backward change
keyhole slot position. (As Shown In Diagram 3a)
To adjust door right or left loosen/tighten
screw. (As Shown In Diagram 3b)
To adjust door up or down adjust bracket height.
(As Shown In Diagram 3c)
Attach the Knob (GG) to the Left Front Door (L) and
Right Front Door (M), insert the bolts attached through
the pre-drilled holes in the doors.
Use a Phillips Head Screwdriver to tighten the bolts.
11
Shelf installation
Choose desired height of Shelf (H) and place the
four Shelf Pin (EE) into same height shelf holes
inside side panels.
Insert Wood Shelf (H), allowing Wood Shelf (H) to rest
on the Shelf Pin (EE).
Hardware Used
Part Description
EE Shelf Pin
Hardware Used
Part
GG
Qty
16
10
Description
Knob
L
GG
H
EE
Qty
2
M