Operation (Continued) - HAMPTON BAY 80434/25MM4495-PB84 Guía De Uso Y Cuidado

Operation (continued)

5
Replacing the remote control battery
When the remote control stops operating or its range
seems reduced, it is time to replace the battery with
new ones. Note: Batteries should be removed if the
product is to be left unused for a long time.
On the back end of the remote, press and slide
the battery door open and remove the old battery.
Insert 2 AAA batteries (not included), checking
that the + and - sides of the battery match inside
the battery compartment.
Replace the battery compartment door.
NOTE:
Do not mix old and new batteries. Do not mix
alkaline, standard (carbonzinc), or rechargeable (nicad,
nimh, etc) batteries.
NOTE:
Please operate remote transmitter at a slow
measured pace. Press the remote control buttons with
an even motion and gentle pressure. Repeatedly pressing
buttons in rapid succession may cause the transmitter to
malfunction.
7
Power cord information
The cord has a plug as shown in figure 1.
Adapters are available (see Fig. 2) for connecting three-
blade grounding type plugs to two-slot receptacles.
The adapter should not be used if a three-slot grounded
receptacle is available.
6
Disposal of used batteries
The battery may contain hazardous substances that
could endanger the enviroment and human health.
This symbol marked on the battery and/or packaging
indicates that used battery shall not be treated
as municipal waste. Instead it shall be left at the
appropriate collection point for recycling.
By correctly disposing used batteries, you prevent
potential negative consequences for the environment
and human health. Recycling used materials also
conserves natural resources.
For more information about collecting and recycling
used batteries, please contact your local municipality,
your waste disposal service or the point of sale where
you purchased this product.
14
Fig. 1
Fig. 2