Assembly, Steps 13 - HAMPTON BAY 80434/25MM4495-PB84 Guía De Uso Y Cuidado

Assembly (continued)
13
Tipping Restraint Hardware installation
When properly installed, this restraint can provide
protection against unexpected tipping of the Unit due
to small tremors, bumps or climbing.
We strongly recommend mounting this hardware to a
wall stud and your unit.
Attach the Tipping Restraint Hardware (KK) to side
back panel of the unit, then use a Phillips Head
Screwdriver to tighten the screws.
WARNING:
You must install the Tipping Restraint
Hardware to help prevent accidents or damage to the unit.
Hardware Used
Part Description
KK Tipping Restraint Hardware
CAUTION:
Cold climate installation recommendation: When installing this unit against a non-insulated exterior wall or chase, it is
mandatory that the outer walls be insulated to conform to applicable insulation codes.
CAUTION:
A 15-Amp, 120-V, 60 Hz circuit with a properly grounded outlet is required. Preferably, the fireplace will be on a dedicated
circuit as other appliances on the same circuit may cause the circuit breaker to trip or the fuse to blow when the heater is in operation. The
unit comes standard with 6-ft. three-wire cord, exiting from the rear of the fireplace. Avoid using an extension cord. If an extension cord must
be used, it must be a minimum 14 AWG, three wire with grounding type plug connector and rated not less than 1875 watts. Do not use an
extension cord more than 20 ft. in length.
Qty
2
12
Wall Stud
Cabinet
Wall
KK