Technical Data; Initial Operation - Bosch Drive Unit Cruise Manual Original

OBJ_BUCH-1407-005.book Page 2 Tuesday, October 8, 2013 9:41 AM
Indication Elements, HMI
a Motor-output indicator
b Assistance-level indicator
c Illumination indicator
d Text indication
e Value indication
f Speed indication
g Battery charge-control indicator

Technical Data

Drive Unit
Article number
Rated continuous output
Torque at drive, max.
Rated voltage
Operating temperature
Storage temperature
Degree of protection
Weight, approx.
HMI
Article number
Max. charging current,
USB connection
Charging voltage,
USB connection
Operating temperature
Storage temperature
Charging temperature
Degree of protection
Weight, approx.
Lighting*
Rated voltage
Power output
– Front light
– Rear light
* Not possible via the eBike battery pack in all country-specific versions,
depending on the statutory regulations
Bosch eBike Systems
Assembly
Inserting and Removing the Battery Pack
For inserting and removing the battery pack in/from the
eBike, please read and observe the battery pack operating in-
structions.
Inserting and Removing the HMI (see figure A)
To insert the HMI 3, slide it from the front into the holder 4.
To remove the HMI 3, press the lock latch 15 and slide the
HMI toward the front out of the holder 4.
Drive Unit
 Remove the HMI when you park the eBike.
0 275 007 006
It is possible to secure the HMI against removal in the holder.
0 275 007 007
To do so, remove the holder 4 from the handlebars. Put the
250
W
HMI in the holder. Screw the locking screw 16 (thread M3,
Nm
8 mm long) from below into the thread provided in the holder.
50
Mount the holder back onto the handlebars.
V
36
°C –5...+40
Checking the Speed Sensor (see figure B)
°C –10...+50
The speed sensor 17 and its spoke magnet 18 must be
IP 54 (dust and splash
mounted in such a manner that the spoke magnet, after a turn
of the wheel, moves past the speed sensor with a clearance of
water protected)
at least 5 mm, yet no more than 17 mm.
kg 4
Note: If the clearance between speed sensor 17 and spoke
magnet 18 is too small or too large, or if the speed sensor 17
Intuvia
is not properly connected, the speed indication f will fail, and
1 270 020 906
the eBike drive will operate in emergency mode.
In this case, loosen the screw of the spoke magnet 18 and fas-
mA
500
ten the spoke magnet to the spoke in such a manner that it
runs past the mark of the speed sensor at the correct clear-
V
ance. When the speed is still not being indicated in the speed
5
indication f after this, please refer to an authorised bicycle
°C –5...+40
dealer.
°C –10...+50
°C 0...+40
Operation
IP 54 (dust and splash
water protected)

Initial Operation

kg 0.15
Requirements
The eBike system can only be activated when the following re-
quirements are met:
V
6
– A sufficiently charged battery pack is inserted (see operat-
2.7
W
– The HMI is properly inserted in the holder (see "Inserting
W 0.3
– The HMI is properly connected (see "Checking the Speed
ing instructions of the battery pack).
and Removing the HMI", page English–2).
Sensor", page English–2).
English–2
0 276 001 YYY | (8.10.13)