Reloop Elite Manual De Instrucciones página 17

2. OPERATION
Power On
After all connections have been carried out, you can turn on the device via the ON/OFF Switch -G54-.
Signal Input Select
Via the Signal Input Select Switch -B11- you can select between line, CD, phono and USB sources for channels 1-2. Please observe the captions of
the single signal input switches.
Gain
Via the Gain Dials -B07- you can adjust the input volume for channels 1 & 2.
Make sure that peak signals are within the green range of the LED indicator -B20-.
Use the Mic Level Dial -F35-, to adjust the DJ microphone and Line Input, respectively.
Equalizer
With the 3-Band Equalizers -B8- you can adjust low, mid and high frequencies for channels 1 & 2.
Via the 2-Band Equalizer -F37- you can adjust low and high frequencies for the microphone channel.
TweakFX
Channels 1 & 2 offer hardware-dedicated effects which can be assigned to the TweakFX Switch -B09-. The ELITE offers the following effects: Filter,
BitCrush, Whitenoise and Flanger. Switching through them can be done by clicking the Mode Button -B10-. In the 12 o'clock position, the filter is
turned off.
Linefader
The Linefaders -B18- are used to adjust the output volume for channels 1 & 2.
The Linefader's curve can be adjusted with the help of the Linefader Curve Dial -F38-.
In the 12 o'clock position the curve is linear. When switching the Reverse Switch -F39-, the linefader signal can be reversed.
Crossfader
With the Crossfader -B19- it is possible to switch between the left and right crossfader channel. The crossfader's curve can be adjusted via the
Crossfader Curve Dial -F40-. By turning counter-clockwise, the crossfader becomes "sharp", namely good for scratching and cutting.
By turning clockwise, the crossfader becomes "smooth", namely good for long mixes.
DJ Mic
By using the Mic Switch you can activate the microphone and, as the case may be, the talkover effect. This results in the suppression of the remai-
ning channels via the microphone signal (Active Ducking Technology).
In the OFF position the channel is turned off. ON activates the microphone's signal, TALKOVER activates the talkover function (Active Ducking
Technology).
Monitoring
With the Cue Channel Select Slider -B17- you can select the input channel(s) that you wish to monitor via your headphones.
With Cue Mix -B16- you can fade between the channel(s) selected via the Cue Channel Select Slider and the master signal. In the CUE position you
will only hear the monitoring channels selected; in MASTER position you will only hear the master signal.
You can mix the signals steplessly. This way you can simulate a mix via your headphones. With the Headphones Input Volume Dial -B15- you can
adjust your headphones' volume level.
Master Section
By using the master dial you can adjust the master output volume.
Make sure that the Master Signal's LED -B20- is only visible in the yellow range.
Adjust the booth output volume via the Booth Volume Dial -B14-.
Via the Mono/Stereo Switch -B13- you can select the booth output's output mode.
NOTE! Rec Output is not affected by the Volume Dials' position.
Under item "Setup Utility MASTER" you can find further information and setting options.
17