At The End Of A Cleaning Session; Maintenance, Cleaning And Decontamination; Filter Disassembly And Replacement; Filter Replacement - Nilfisk T30S Manual De Instrucciones

At the end of a cleaning session

■ Turn off the vacuum cleaner and remove the plug from
the socket.
■ Wind the connection cable around the cable carrier
(Figure 12).
■ Empty the container as described in the "Emptying
the container" paragraph. Clean the vacuum cleaner
as described in the "Maintenance, cleaning and
decontamination" paragraph.
■ Wash the container with clean water if aggressive
substances have been vacuumed.
■ Store the vacuum cleaner in a dry place, out of reach of
unauthorised people.
Maintenance, cleaning and
decontamination
WARNING!
The precautions described below must be taken
during all the maintenance operations, including
cleaning and replacing of the filter.
To allow the user to carry out the maintenance
■
operations, the vacuum cleaner must be
disassembled, cleaned and overhauled as far as
is reasonably possible, without causing hazards
for the maintenance staff or other people. The
suitable precautions include decontamination
before disassembling the vacuum cleaner,
adequate filtered ventilation of the exhaust
air from the room in which it is disassembled,
cleaning of the maintenance area and suitable
personal protection.
Compartments that are not dust-tight must be opened
with suitable tools (screwdrivers, wrenches, etc.) and
thoroughly cleaned.
■ Carry out a technical inspection at least once a
year, e.g.: check the air filter to find out whether
the air-tightness of the vacuum cleaner has
been impaired in any way and make sure that
the electric control panel operates correctly.
This inspection must be carried out by the
manufacturer or by a competent person.
WARNING!
Use only genuine spare parts supplied and authorized
by the manufacturer.
01/2015

Filter disassembly and replacement

WARNING!
When the vacuum cleaner is used to vacuum
hazardous substances, the filters become
contaminated, thus:
■ Work with care and avoid spilling the vacuumed
dust and/or material.
■ Place the disassembled and/or replaced filter in a
sealed plastic bag.
■ Close it hermetically.
■ Dispose of the filter in accordance with the laws
in force.
WARNING!
Filter replacement is a serious matter. The filter must
be replaced with one of identical filtering surface
characteristics.
Otherwise the vacuum cleaner will not operate
correctly.

Filter replacement

1 Suction hose
2 Band
3 Cover
Before proceeding with these operations, turn off the vacuum
cleaner and remove the plug from the power socket.
■ Remove the vacuum hose (1).
■ Use the band (2) to remove the cover (3) together with
the filter.
■ Remove the old filter from the cage.
■ Fit the new filter and secure it in the cage with special
clamps.
■ Install the cover and the filter in the reverse order of
removal.
■ Dispose of the old filter according to the laws in force.
9
Figure 13
T30S
GB
C341