Cleaning; Troubleshooting - Britax ADVOCATE Guia Del Usuario

Britax Child Safety, Inc.

Cleaning

Shell • SPONGE CLEAN
and Side the shell using warm
Impact water and mild soap.
Cushions • TOWEL DRY
Prevent the Side Impact Cushions from being punctured.
Puncture damage will cause the cushions not to perform
as intended.
Cover • HAND WASH the
cover using cold
water and mild soap.
• LINE DRY to prevent
the cover from
shrinking.
Harness • SPONGE CLEAN the
harness using warm
water and mild soap.
• TOWEL DRY
Harness • THOROUGHLY
Buckle RINSE the buckle
using warm water.
• TEST THE BUCKLE
by fastening and
unfastening until a
click is heard after
inserting each buckle
tongue. If clicks are
not heard, repeat the
cleaning procedure.
• TOWEL DRY
Anti- • SPONGE CLEAN the
Rebound anti-rebound bar using
Bar warm water and mild
soap.
• TOWEL DRY.
44
All manuals and user guides at all-guides.com
DO NOT
• Use abrasive
cleaners.
DO NOT
• Bleach
• Machine wash
• Machine dry
• Iron
DO NOT
• Disassemble the
harness
• Bleach
• Machine wash
• Machine dry
• Iron
DO NOT
• Soak
• Lubricate
• Use solvents
• Use soap or
household
detergents
DO NOT
• Disassemble
• Bleach
• Machine wash
• Machine dry
• Iron
ADVOCATE/BOULEVARD CLICKTIGHT User Guide

Troubleshooting

Problem
The There may be debris or other objects
CLICKTIGHT
interfering with the mechanism.
will not close
Ensure the seat area is clear of any
with a click to
obstructions and try closing the
signal that
CLICKTIGHT again.
it is secure�
There may be too much tension in
the belt/strap. Do not overtighten
the belt/strap before closing the
CLICKTIGHT. Only remove slack.
The logo on the Press down again on the
CLICKTIGHT dial CLICKTIGHT to the left and right of
will not return the bezel to ensure the CLICKTIGHT
to a horizontal pins have fully engaged.
position�
The harness There may be debris in the
release button
mechanism. Clean the mechanism,
will not operate�
then try using the button again.
The harness Check the seating position where
cannot be
the child seat is installed. The vehicle
adjusted to its
head restraint may obstruct the path
full height�
of the child seat harness height
adjuster. Remove or raise the vehicle
head restraint and try adjusting the
harness height again.
The harness The harness can be adjusted to a
cannot achieve
shortened length for use with small
a snug fit�
infants (approx. 10 lbs and under).
See pages 23-24 for instructions on
adjusting the harness length.
The harness is Check for harness twisting and
hard to adjust�
ensure that the comfort pads and
impact absorbing chest pads are
not interfering with the harness. Pull
comfort pads and impact absorbing
chest pads down.
The harness is Pull comfort pads and impact
uneven�
absorbing chest pads down. Hold
harness straps up and away from
seat while closing the CLICKTIGHT.
The buckle will There may be debris in the buckle
not fasten with
mechanism. Clean the buckle (see
a click after
page 44), then try fastening the
each tongue is
buckle again.
inserted�
Please contact Britax Consumer Services at 1-888-427-
4829 or 1-704-409-1699 if you have an issue not listed
here.
Possible Solution
45