Grinding Mode; Standard; Automatic; Pre/Sel - Fiorenzato F64E Manual De Instrucciones

GRINDING MODE

Standard

Press for the required dose using the buttons
or . The selected button will begin to
flash . When the filter holder cup is pressed,
the start microswitch activates grinding . When
the button is pressed, continuous grinding
is activated until the button is released . The
Standard mode is factory-set . To reselect it, ac-
cess the settings menu, select Grinding Mode
and then Standard . In this way, the buttons will
light up .

Automatic

Access the settings menu, select Grinding Mode
and then Automatic . For a single dose, press
the start microswitch once with the filter hold-
er cup . For a double dose, press twice quickly .
In this way, the coninuous grinding (button
and the buttons

PRE/SEL

Access the settings menu, select Grinding Mode
and then PRE/SEL . Press the required dose us-
ing button or
remain on and active . Grinding starts when the
start microswitch is pressed by the filter holder
cup . To switch from one dose to another, press
the appropriate button . In this way, continuous
grinding (button

Direct

Access the settings menu, select Grinding
Mode and then Direct . Press the required
dose by using the button
button is pressed, continuous grinding is
activated until the button is released . In this
way, the start microswitch is deactivated
and the buttons light up .
• During the grinding process, the time is dis-
played in seconds and tenths of a second .
• The button for the selected dose flashes dur-
ing dispensing .
• After dispensing, the counters are updated .
• For counting purposes, continuous grinding
corresponds to a single dose .
and are deactivated .
. The selected button will
) is deactivated .
or . When the

ADJUSTING GRINDING

In order to achieve finer or coarser grinding
and therefore vary the granulometry, use the
adjustment disk located under the hopper . To
increase the coarseness of the ground coffee,
the adjustment disk must be rotated clock-
wise, pressing the adjustment disk lock down-
wards, to decrease turn the disk anticlockwise .
The adjustment must be performed with the
motor on, and possibly without coffee between
the grinding blades .
)
It is advisable to grind small amounts of coffee
to facilitate a visual check of optimum granu-
lometry and, if required, adjust the grinding
adjustment disk . If the coffee comes out of the
espresso coffee machine very quickly, it means
that the coffee is ground too coarse . Vice versa,
if it comes out too slowly, it means the coffee
is ground too fine . Nonetheless, bear in mind
that there are many conditions liable to influ-
ence the correct supply, such as the weight of
the portions, the compacting, the espresso ma-
chine settings and the cleaning of the filters .

SAFETY DEVICES

Thermal overload protection
The grinder-doser motor is protected against
overheating resulting from overcurrents by
a thermal overload protection which, when
tripped, cuts off the power supply to the mo-
tor . If the thermal protection device should au-
tomatically turn on in the event of anomalous
operation (such as the grinding blades jam-
ming), turn off grinder-doser using the On-Off
switch, unplug it from the mains, and contact
skilled technical personnel . Never perform any
work on the grinder-doser while it is attached
to the mains, in order to prevent the motor
22