General Warnings; General Description - BOREAL E4000 Serie Instrucciones De Instalación, Uso Y Mantenimiento

1. GENERAL WARNINGS

The installation of a stove must be done according to the local, national or European regulations.
Our liability is limited to the supply of the equipment. The installation must be done according to the procedures expected for this kind of equipments,
EN
according to the indications included in this manual and the rules of the profession. The fitters must be qualified, with official license and they will work
for enterprises that accept responsibility of the installation.
The manufacturer will not be responsible for the modifications made to the original product without the prior written permission as well as for the use of
non-genuine spare parts or pieces.

2. GENERAL DESCRIPTION

The equipment that you have purchased contains the following pieces:
- Stove body placed on the pallet.
- Inside the combustion chamber you can find: a box/bag with a thermal glove that allows us to handle the air controls and door. The smoke
baffle-plate.
- In models with cooker you will find as well a barbecue kit. As well as a safety bolt in a bag to place and avoid accidental closing of the top
cover.
- In E6000 series you will find a plastic protector for seasonal stops.
- In the metallic fireplaces, you will find a telescopic grill
The equipment is made of several elements of steel sheets welded, with different thickness, and vermiculite (orange-coloured refractory material that
covers the walls). It also has a panoramic door with vitro ceramic glass (resistant up to 750ºC) and ceramic cord for the air tightness of the combustion
chamber.
Heating is produced by:
a. Convection: because the air passes through the hood or the body, the stove gives off heat.
b. Forced convection (only models with turbines): thanks to the turbine placed on the bottom, the air at room temperature is aspired and it is
returned to the room at a higher temperature
c. Radiation: through the vitro ceramic glass and the body the heat is irradiated towards the environment.
The models have some settings for a perfect combustion control:
The primary air intake
Controls the air that passes through the ash pan and the grate towards the fuel. The primary air is necessary for the combustion process.
The ash pan should be emptied frequently so that the ash does not block the primary air intake for the combustion. Also, the primary air rekindles the fire.
The regulation is located under the door and you have to make a left-right moving: the movement to the right means more flow entrance , except in the
case of the models CH4000EI, CH4000EIS, I70EI, I70EIS, I90EI and I90EIS which is on the contrary.
The secondary air intake
Favors the carbon that was not burnt during the first combustion can suffer a post-combustion. This increases the efficiency and assures that the glass
keeps clean. The entrance is located at the top between the door and the glass. Is not adjustable.
Primary air regulation
Double combustion
With this system we get a second preheated entry air inside the combustion chamber. This allows a second combustion of the not burnt gases in the
first combustion that achieves a high performance efficiency, a great fuel saving and reductions in pollutant emissions. There is a back pre-heated flow
entrance at the back, but is not adjustable. This flow comes through some little holes placed at the combustion chamber wall.
The combustion is not always stable. In fact, it can be affected by the weather conditions or the outside temperature. This modifies the draft of the
equipment.
16
Secondary air intake