Static Electricity - Binks MX1231 Manual De Servicio

EN
HAZARD
EXPLOSION
SPECIAL
CONDITIONS
FOR SAFE USE
REQUIRED
BY ATEX
CERTIFICATION
EC Declaration of Conformity
We: Finishing Brands, Ringwood Rd., Bournemouth, Dorset, BH11 9LH, UK
As the manufacturer of the items listed below:
Declare, under our sole responsibility, that, the equipment to which this document relates is in conformity with the fol-
lowing standards or other normative documents:
EN 13463-1:2009, EN 13463-5:2005, EN 982:1996 + A1:2008, EN 983:1996 + A1:2008 and EN 12621:2006
And thereby conform to the protection requirements of Council Directive 98/37/EC relating to Machinery Safety Directive and
council Directive 94/9/EC relating to Equipment and Protective Systems intended for use in Potentially Explosive
Atmospheres;
Issued on: 1st July 2009
Authorized by:
General Manager
Technical file lodged with;
TRL Compliance Ltd (Notified Body 0891)
Moss View
Nipe Lane
Up Holland
WN8 9PY, UK
CAUSE

STATIC ELECTRICITY

Use of this equipment in
a potentially explosive
atmosphere.
Vapors from flammable
liquids can catch fire
or explode from static
electricity discharges.
Over pressurization of
equipment can cause
equipment failure or injury.
Use lubricating medium
resistant to carburisation.
Improper operation or
maintenance may create a
hazard.
Piston Pumps MX1231
SAFEGUARDS
1. If installing this equipment in a potentially explosive
atmosphere, check the ATEX equipment category and
temperature ratings meet the requirements for the
zoned area.
2. Check electrical continuity of the air supply to earth —
should be no greater than 10
3. Electrically bond all metallic equipment to earth.
Should be no greater than 1 .
1. Do not exceed the stated maximum working pressures
and motor speed as specified in this manual.
2. Only a suitably approved static dissipating or
conductive air supply hoses shall be attached to the
equipment and terminated to the air supply.
3. Air supplies (compressors, etc.) shall be sited in a non-
hazardous area with a filter on the air intake system to
prevent the ingress of dust or similar foreign material
into the parts where compression takes place.
4. Use lubricating medium resistant to carburisation and
has an auto ignition temperature of more than 185ºC
for T4 equipment.
5. User shall ensure all metallic parts of the equipment
are suitably bonded to earth. Should be no greater
than 1 .
CE Ex 2 II Gc T4
4 / 12
6
.
77-2919-R6.3 (8/2015)