salmson MULTI-VE 2G Instalacion E Instrucciones página 23

Bombas verticales multi-etapas en acero inoxidable
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

ENGLISH
6. STARTING UP
If the pump is delivered as separate part, not inte-
CAUTION !
grated into a system we mounted, the standard
configuration mode is MODE 1.
6.1 Configurations
The converters will be equipped with touch pads :
Setting with touch pads :
The selection of a new parameter is done with impulsion on arrows for
touch pads.
« + » on top and « - » on bottom.
A short impulse on the center of touch pads validates this new setting.
This variator is composed of a two switches block with two positions
each (fig. 4 - item S) :
Switch 1
- The SERVICE position is used to enter the parameters of the different
modes.
- The OPERATION position allows the selected mode to run and hin-
ders the access to parameters input (normal operating).
Switch 2
- The position is used to lock the touch pads.
- The position allows to use the touch pads.
Example : Locking of set value in mode 1 or 2.
6.1.1 Manual mode : MODE 1
When changing the motor speed with the touch pad you reached
the operating point.
Parameters input in Mode 1
(If the pump is new and not integrated inside a system, parameters
are already in with operation in Mode 1 ; (see § "Operation in Mode 1").
- Set the switch (fig. 4 - item S) on position Service.
- Select " M1 ".
- Validate
- Visualisation of the Operating time meter. (number of pump opera-
ting hours)
- Validate
- Set the switch again on position OPERATION.
Operating in Mode 1
For the starting up, we recommend to set the motor speed at 2400
RPM.
By the touch pad the requirement value can be changed.
- Validate the new value
With a short impulse on the touch pad the actual speed can be dis-
played ; after 30 seconds or a new impulse the requirement value
reappears.
An impulse ~1s allows the ON/OFF function.
- Select OFF.
- Validate.
Note: the remote control (ex : switch) allows a stop of the pump
(variator ON).
When stopping the pump, the sign "OFF" appears.
ON
SERVICE
1
2
ON
1
2
MODE 1 - Manual mode
23
0,1s or 1s
ON
OPERATION
1
2
ON
1
2
ON
SERVICE
1
2
0,1s
0,1s
ON
OPERATION
1
2
0,1s
1s
0,1s
1s
0,1s

Publicidad

Tabla de contenido
loading

Tabla de contenido