How To Assemble Your Ceiling Fan Blade Holder And Blade Support - Fanimation KINDRED Manual Del Usuario

How to Assemble Your Ceiling Fan (continued)
6. Reinstall the hanger ball on the downrod as follows.
Route the brown, blue, red, gray and yellow wires
through the hanger ball. Position the pin through the
two holes in the downrod and align the hanger ball so
the pin is captured in the groove in the top of the
hanger ball. Pull the hanger ball up tight against the
pin. Securely tighten the set screw in the hanger ball.
A loose set screw could create fan wobble. (Figure 6)
7. Cut off excess lead wire approximately 6 to 9 inches
above top of the downrod. Strip insulation off 1/2 inch
from the end of each lead wire. (Figure 7)
NOTE: All set screws must be checked, and retightened
where necessary, before installation.
8. Remove one of the two shoulder screws in the
hanger bracket and retain the screw for later. Loosen
the second shoulder screw without fully removing it.
(Figure 8)

How to Assemble Your Ceiling Fan Blade Holder and Blade Support

1. Remove and discard the five rubber/screws motor
stops from the motor assembly. (Figure 1)
8
Figure 6
Figure 7
Figure 8
Motor Assembly
Motor Stops
Figure 1