Hudson 91064CCV Manual De Instrucciones

FOR YOUR SAFETY
This sprayer operates with liquid under pressure.
Failure to observe cautions and follow instructions for
use and maintenance can cause tank, hose or other
parts to become corroded, weakened, and/or burst.
This can result in serious injury or property damage
from forcible ejection of parts or high-pressure
discharge of spray material. Do not use any flammables
or boiling liquids in this sprayer as it is not designed
nor intended for such use. Some spray materials can
ignite or explode. Do not spray in an enclosed space,
near an open flame such as found in a bbq grill or
water heater, near an electric motor or open switch, or
any source of heat. Do not smoke while spraying. Use
of flammables could result in serious injury or property
damage from unintended ignition or explosion. Do
not use any caustics or acids, bleach, or acetone in
this sprayer, since these can damage or weaken the
sprayer and its parts, resulting in serious injury or
property damage. Keep out of reach from children and
pets. Always read and follow directions on the spray
material container, including the need for protective
clothing. Before using your sprayer, thoroughly
inspect both inside and outside of the sprayer and
do not pressurize sprayer if tank, hose or other parts
appear to be damaged, discolored, brittle, excessively
soft or loose. Do not pressurize with any mechanical
device such as an air compressor, since this can create
dangerous pressure and bursting of parts and result in
serious injury. Wear long-sleeved shirt, pants, gloves,
goggles or similar protective clothing when spraying.
PROP 65 WARNING: This product contains one or
more chemicals, including lead, known to the State of
California to cause cancer and birth defects or other
reproductive harm. Wash hands after handling.
LIMITED WARRANTY
H. D. Hudson Manufacturing Company warrants to
the original consumer purchaser of this product at
retail that it is free from problems in materials and
workmanship for the period of 1 year from the original
date of purchase. This warranty does not apply to
damage to the product resulting from accident,
misuse, neglect, alteration, modification, tampering,
or failure to follow instructions supplied with the
product. This warranty does not cover normal wear
and tear of o-rings or seals, and the warranty shall
be void if the product is used commercially. If the
product or any part of it should malfunction within
the warranty period, call 1-800-977-7293. Valid only in
North America.You must retain your sales receipt as
proof of the date of purchase and include it with any
return of the product.
H. D. HUDSON MANUFACTURING COMPANY EXCLUDES
LIABLITY UNDER THIS WARRANTY FOR ANY AND ALL
INCIDENTAL AND CONSEQUENTIAL LOSS OR DAMAGES.
Replacement Part Kit: #91210V 871-525 Instruction
91064CCV Constructo®
Galvanized Steel Sprayer Instructions
If you have any questions or concerns, or missing parts, Do not return sprayer to the store!
Call our hotline: 1-800-9-SPRAYER (1-800-977-7293)
Common maintenance questions: www.hdhudson.com/FAQS
INSIDE THE BOX
(Parts may be loose in tank)
• Sprayer tank with supply tube • Nozzle Tip
• Hose with Fitting and Nut • Instructions
• Pump in Tank
• Shut-off Valve
View Online
Poly Tank Assembly Video @ hdhudson.com
HOW TO ASSEMBLE
1.
Assemble Hose
Hose to tank: Securely thread on the cap nut.
CAUTION: Make sure the cap nut is threaded all the
way down. If loose, it may come off with force or spray
may escape resulting in injury.
2. Attach spray wand to shut-off valve.
• Insert spray wand fitting into shut-off valve.
• Screw down wand retainer cap nut onto valve.
Screw nut onto the shut-off valve. Note: This is not
a compression fitting, but it is normal for nut to
screw on tightly.
1.
.
2
View Online
See maintenance and instructional videos on the internet:
www.hdhudson.com/instructional-videos
HOW TO FILL
A.) Pour measured amount of spray material into
the open tank. Follow label directions on spray
material container for amount to use.
B.) Add water as directed.
Do not fill beyond the MAX FILL line.
C.) Insert pump and turn clockwise to seal.
Do not over tighten.
A. B.
C.
HOW TO PRESSURIZE
Unlock pump handle by pushing down and turning
handle. Do not unscrew pump cap or remove
pump. Using the handle, pump up and down. The
more you pump, the more pressure you will build
up inside the tank. When it becomes difficult to
pump, your tank has reached maximum pressure.
Do not stand so your head is over pump.
• Use low pressure (fewer strokes) for a coarse spray.
• Use high pressure (more strokes) for a fine mist or
a long-reaching stream.
©2016 Manufactured by H. D. Hudson Manufacturing Company
HOW TO SPRAY
Squeeze handle to spray
Release handle to stop
HOW TO RELEASE PRESSURE
Turn sprayer on its side and turn nozzle away from
you. Squeeze lever or push button to "ON" and let
all the air escape. Turn sprayer up-right and slowly
unscrew pump from tank and remove it. Do not
stand so your head is over pump.
SERVICE AND MAINTENANCE
Visit www.hdhudson.com/FAQS
Clean and dry your sprayer after every use to
greatly prolong its useful service life. Many spray
materials will harden if left in the sprayer and plug
up the nozzle, shut-off valve or supply tube. The soft
parts, O-rings and gaskets, will ultimately wear out
and need replacing, just like the oil filter on your
car, for example. How often they need replacing
depends on how much you spray, the spray materials
you use and whether or not the sprayer is regularly
cleaned after use. Call 1-800-9-SPRAYER or visit
www.hdhudson.com to obtain genuine Hudson®
replacement parts. If you leave your sprayer in the
garage over Winter, particularly in northern areas, the
soft parts may dry out and need servicing before you
use your sprayer for the first time in the Spring.