Front Panel - Wagan Tech Slimline 250 Manual De Usuario

• If you operate the inverter in a moving vehicle, you need to secure the inverter to prevent it
from shifting around while the vehicle is moving.
• If there is anything wrong with the inverter, disconnect all power.
• The following operations will damage and void the warranty of the inverter:
• Reversing polarity by connecting DC cables to incorrect terminals.
• Connecting the inverter to a power source greater than 15V DC

FRONT PANEL

All inverters described in this manual have an ON/OFF rocker switch, two LED indicators, and
multiple AC outlets. Actual locations of these components vary by model. Multiple AC outlets
enable multiple appliances to be operated at one time.
ON/OFF Switch – Controls operation of the inverter. The below indicators operate when the
switch is ON.
Green LED – When lit, indicates the inverter is on and operating normally. AC is present at the
outlets.
Red LED – When lit, indicates the inverter has shut down for any of the following reasons:
1. Low DC battery voltage – less than 10.5V
2. Preceded by an audible alarm. Charge the battery as soon as possible.
3. High battery voltage – greater than 15V
4. Over temperature − Shut off the inverter and let it cool before restarting.
5. Overload – reduce the AC appliance load.
Audible Alarm (not shown) – when it sounds, it indicates that the battery voltage is getting low
and the inverter is about to shut down. If you can reduce the AC load, you can temporarily
extend operating time. Charge the battery as soon as possible.
Wagan Tech and wagan.com are trademarks of Wagan Corporation.
User's Manual—Read before using this equipment
©2017 Wagan Corporation. All Rights Reserved.
Vents
Power On Indicator (green)
Fault Indicator (red)
ON/OFF Switch
2x AC Outlets
4