LawnMaster NPTGCP2517B Manual Del Usuario página 12

ASSEMBLY
FITTING THE DEBRIS GUARD (See Figs. 1-3)
WARNING
The trimming line cutting blade on the debris guard is sharp and is fitted with a blade protection film
which will need to be removed prior to using the trimmer. When fitting the guard avoid contact with
the blade. Failure to avoid contact can result in serious personal injury.
■ Loosen and remove the screw from the debris guard using the screwdriver provided.
■ Starting from the top of the split shaft, slide the debris guard all the way down to the correct mounting
position as shown (Fig. 1).
■ Align the screw hole on the debris guard with the screw hole on the bracket. Insert the screw through the
debris guard and the bracket on the shaft (Fig. 2).
■ Secure the screw tight using the screwdrive (Fig. 3).
INSTALLING AND REMOVING THE SHAFT (See Figs. 4-6)
WARNING
Never install, remove, or adjust any attachment while the engine is running. Failure to stop the engine
can cause serious personal injury.
To install the shaft:
■ Turn the locking collar counter-clockwise to remove it from the shaft connection sleeve. Slide the locking
collar onto the shaft.
■ Check to ensure the axles in the shafts are aligned as shown (Fig. 4). If not aligned, slightly rotate the
trimmer head to adjust the axle until it aligns.
Hole on the
debris guard
Fig. 1
Hole on the
bracket
Fig. 2
12
Fig. 3