LawnMaster NPTGCP2517B Manual Del Usuario página 28

MAINTENANCE
■ Refer to the Line Replacement section in this manual if only the line needs to be replaced.
■ Install the spring to the new spool. Insert the new spool with spring into the spool cover. Release
both trimming lines from the parking slot and guide the lines into both eyelets (Fig. 31).
■ Install the whole main spool cover back to the grass trimmer. Hold the main spool cover, install the
spool head onto the main spool cover, and turn clockwise to secure it (Fig. 32).
LINE REPLACEMENT (See Figs. 33-35)
■ You may wind new cutting lines onto an empty spool.
■ Replacement cutting line is available from a DIY store or online.
■ Remove the empty spool from the grass trimmer as described above.
■ Remove any remaining cutting line from the spool.
NOTE: Use only round monofilament line with the recommended diameter.
■ Ensure that the new cutting line is sufficiently long, approximately 13 ft (4 m). Fold the line in half
and then adjust it so that one end is approximately 3.5 in. (9 cm) longer than the other (Fig. 33).
Fig. 31
Fig. 33
28
Fig. 30
Fig. 32