Troy-Bilt 020242 Instrucciones De Uso página 4

Section 1: Safety Rules
WARNING
DO NOT touch hot surfaces,
Allow equipment to coo[ before touching.
The pressure washer must be at least 5 feet from structures
having combustible wails and/or other combustible materials.
Keep at least 3 feet of clearance on aJIsides of pressure
washer for" adequate cooling, maintenance and servicing.
Reflecuve exhaust heat may damage fuel tank causing fire.
Code of Federal Regulation (CFR) Tide 36 Parks, Forests, and
Public Property require equipment powered by an internal
combustion engine to have a spark arrester, maintained in
effective working order, complying to USDA Forest service
standard 5100-IC or" later revision. In the State of California a
spark arrester is required under section 4442 of the California
Public resources code. Other states may have similar laws.
WARNING
DO NOT wear Ioose clothing, iewelry or anything that may
be caught in the starter" or other rotating parts.
, Tie up long hair" and remove jewelry:
WARNING
WHEN
ADJUSTING OR MAKING REPAiRSTOYOUR
PRESSURE WASNER
Disconnect spark plugwire from spark plugand placewire
where it cannot contactspark plug.
WNENTESTING FOR ENGINE SPARK
Use approved spark plug tester:
DO NOT check for spark with spark plug removed.
WARNING
CAUTION
DO NOT tamper with governed speed.
DO NOT operate pressure washer above rated pressure.
CAUTION
DO NOT secure spray gun in open position.
DO NOT leave spray gun unattended while machine is
running.
NEVER use a spraygun which does not have a trigger loci< or
trigger guard in place and in working order:
Aivvays be certain spray gum nozzJes and accessories are
correctly attached.
DO NOT point spray gun at glass when using MAX (pin
point) nozzle.
NEVER aim spray gun at plants.
If you have questions about intended use, ask dealer or
contact Briggs & Stratton Power Products.
NEVER operate units with broken or missing parts, or
without protective housing or covers.
DO NOT by-pass any safety device on this machine.
Before starting pressure washer in coId weather, check all
parts of the equipment to be sure ice has not formed there.
NEVER move machine by puIIing on high pressure hose. Use
handle provided on unit.
Check fuel system for Ieaks or signs of deterioration, such as
chafed or spongy hose, loose or missing damps, or" damaged
tank or cap. Correct alJ defects before operating pressure
washer_
This equipment is designed to be used with Briggs & Strat_on
Power Products authorized parts ONLY. If equipment is used
with parts that DO NOT compIy with minimum specificadons_
user assumes all risks and liabilities_
, Always wear eye protection when using this equipment or in
vicinity of where equipment is in use.