Troy-Bilt 020242 Instrucciones De Uso página 6

ASSEMBLY
mMPORTANT: Read endre owner'smanuaH beforeyou
attempt to assembie or operate your new pressure washen
If you have any questions with the assembiy of your pressure
washer, piease cali the pressure washer heipilne at
1-888-61 1-6708. If calling for assistance_piease have the
model revlslon_ and serlai number from the data tag avaiiabie.
See "Know Your Pressure Washer" for data tag iocatlon.
Remove Pressure Washer from
Carton
o Remove the parts bag packed with pressure washer.
, Siice two corners at the end of carton from top to
bottom so the pane[ can be foided down flat_ then
remove all[packing material
, Roll[ pressure washer out of carton.
Carton Contents
mtemTms in the carton include:
° Hain Unit
Safety Goggles
Handle
Plastic Accessory Tray
High Pressure Hose
Spray Gun
Nozzie Extension with Quick Connect Fitting
Oil Bottle
Parts Bag (which inciudes the following):
Owner's Hanual
Engine Hanual
Owner's Registration Card
Bag containing 4 multi-colored ProjectPro TM
Nozzles
Handle Fastening Hardware Kit (which includes):
Carriage Bolt
"L" Bolt (2)
Plastic Knobs (3)
Tree Clips (4)
PREPARING PRESSURE
WASHER FOR USE
If you have any problems with the assembly of your
pressure washer or if parts are missing or damaged, call the
pressure washer heIpline at 1-888-611-6708.
To prepare your pressure washer for operation, you
wili need to perform these tasks:
I. Fill out and send in registration card.
2. Attach handle to main unit, then attach accessory tray
to handle.
3. Add oil to engine crankcase.
4. Add fuel to fuel tank.
S. Connect high pressure hose to spray gun and pump.
6. Connect water supply to pump.
7. Attach nozzie extension to spray gun.
8. Select/attach quick connect ProiectPro TMnozzie to
nozzie extension.
Attach Handle and Accessory Tray
I. Place handle onto handle supports connected to main
unit. Hake sure holes in handle align with holes on
handle supports (Figure I).
Handle
Align
NOTE: It may be necessary to move the handHe supports
from side to side in order to align the handle so it will slide
over the handle supports.
O